2 Channel Amp Wiring Diagram

This amp is only a two channel amp, but it delivers...

Took some research to make sure it was compatible, found the right wiring diagram. Installation was easy. Works as advertised. Highly recommended.

This case is the easiest case I have ever built in. I didn't need the drive bays (I used M.2's) so I took them out. The support in back is removable to make wiring easy. Plus it is big enough to hold my GPU with plenty of room to spare.

This is a solid integrated amp. I have an RME ADI-2 DAC feeding the CD inputs with the amp set to its CD Direct mode for a straightforward analog signal path. I use the DAC's volume control and leave the Yamaha volume at about 12 o'clock for convenience, with suitable gain for my setup. Since the amp has A and B sets of speaker outputs, and my speakers have a bi-wiring option, I decided to separately feed the speaker's high and low frequency inputs from the amp's A and B outputs. Then, for initial testing of my wiring, I switched A-only or B-only on the amp, to confirm I would hear high-only or low-only sound. That showed my connections were as intended. Then I left the amp switched to feed both A and B. My wiring is nothing fancy, just Monoprice 14-gauge OFC, and this bi-wired hookup is similar to using a single, heavier gauge cable.

I was getting some feedback in my turntable setup and after separating some wires, i realized it was in the wiring connecting my turntable, preamp and amp. I grabbed these because they looked high quality and were a good price. I was not disappointed. As a beginning audiophile, these definitely solved all the feedback problems i had.

I needed a 4 channel headphone amp for a small project and this certainly over delivered in terms of sound and value.

Thanks cardioid diagram, I have much less outside sounds and noise.

I Used this amp to expand my RZ50 from 7.2.2 to 7.2.4 so now I can run 4 Atmos speakers and it sounds so much better. I was missing the back atmos now I have full 360 degree sound. This amp sounds great . I have it powering my klipsch RP-600M as my surround rear speakers plug into the RCA pre output. Then you take and wire your rear height/ atmos speakers into the surround rear speakers positive and negative post . Then when you set your speaker configurations to 7.2.4 it gives you a second height channel but takes away your rear surround and that’s why you use this 2 channel amp for your rear surrounds .

Blew out my midrange amp (50W/channel) and replaced it with a Samson 120A right away. Got it from B&H in 48 hours. Took about 10 minutes to install. Sounds great! Appears to be built like a tank! No unnecessary frills, just a quality industrial design. Highly recommend this little guy for medium powered audio systems! Will buy again from B&H, too!

I use this in a small home studio. This is a strong headphone amp with many features including support for two headphones per channel. VU meters for each channel including input. Seems a bit fragile, but no problems for me with use. Definitely a good value with good features. Headroom is excellent and output is very strong.