24 Volt 50 Amp Hour Lithium Battery

I put two LP-E6NH Lithium Ion Batteries inside my battery grip and it lasted me well over a 8+ hour day of shooting! I am super happy with this purchase. Its a huge bonus in my eyes how light weight this is too. Great product and speedy shipping from B+H.

This lithium battery is very reliable.

So all I can say is I got these as part of a 24-hour sale, and I'm delighted to have them! I get over 2,000 lux at one meter with the two of them, they're easy to place thanks to the screws in the bottom and the fold-out brackets, and while they only last a half-hour each on battery power I extend that with 10,000 or 20,000 mAH battery packs or AC. It's enough light to do a basic stand-up or fill in light where I need it....

They said to remove the vent cover a half hour before use. I removed the cover and measured about a half volt. An hour later, 1.35 volts. Installed them, and now my vintage Luna Pro works perfectly! Great solution to replace an obsolete part!

worked just like the product I replaced except uses a double A battery instead of a nine volt.

I replaced a noisy fan cooled amp with this one, and it is driving eight 70 Volt 5 Watt ceiling speakers in our church's overflow areas easily.

This mic is used in a 24 hour live broadcast and works well.

A deep channel and sturdy construction makes it ideal for a 50 ft 240 volt cable across my yard and into the driveway for charging my EV, along with a 120 volt cable for a PHEV.

Yes you will get some bass roll off in the very very low end, so it will not go down to 5 hz like a set of 800.00 aphex 124a or 750.00 Arx distribution split. The 20 db of gain is a big plus, and of course having level control pots on all outputs, is an excellent feature. IF you are using to drive multiple low end subwoofers, you may wish to change the output capacitors. Existing ones are 10 uf 50 volt polar electrolytic, and you can easily change for 100 uf 50 volt polar electrolytic for a few dollars. Once you open the case these can easily be seen. The capacitors are easily available and are not expensive. If you try this you will need a solder sucker. Do not try soldering without one. Suck up all the old solder and remove the caps and replace all of then in the existing threw holes. They are marked for positive and negative on the pc board. Once you got them all in place just solder them back in. Once you do this for a few more dollars you can rival any expensive distribution amp. Would be nice if it was more than just 3 inch deep on the case. Most components are at least 6 inches.

This manual flash has everything I need and especially like the lithium battery. just bought a second unit.