24 X 48 Desk With Left File Drawers

The rip tie was perfect for organizing all of the loose cables that i had in my desk drawers.

These are just perfect for me for moving slides from trays to a much more compact yet searchable storage that can go in either file drawers or binders.

This box will hold 3’x 4’ photographs. It is on the expensive side but is WAY less expensive than the flat file blueprint drawers! I am quite happy with it and it was delivered promptly as is always the case with B&H.

Perfect fit for an AutoDesk standing desk. I mounted two side by side an they look like original equipment. These are not as deep as other drawers but then again those other drawers could not be mounted properly on a “Standing Desk.” Solid build and packaged well. Tidy's up my desk nicely.

Great card storage device! I was always searching through desk drawers and camera bags for lost cards. But no more!

I purchased the 48 boom arm to go over top of my monitors. I changed my mind when I redesigned the office and now the arm sits on the side. Each segment is about 24 inches. The next smaller size would have been a better choice for the current setup. With the larger arm it will cover most of my desk if I choose to work on the other side of the desk. The desk to 70 inches long. I choose to clamp it to the desk instead of drilling a hole. If your desk has a grommet hole, it should work there too. The arm is stiff and I find you need to pull it at the connection joints for easier movement. It hold the Samson G Track Pro with Shockmount well.

If you need to quickly and inexpensively add 2T of external storage to your PC, this little SSD does the trick. I am on Win-10. Plug into USB-3 port, drive is immediately recognized and ready for use. Default file format is the old slow FAT. In File Explorer, right click on new SSD drive, left click on "Format", select "File system" = "NTFS", left click on "Start". Now you are ready to go.

This converter is used to interconnect a legacy stereo system with a modern digital one. The D to A converter is also compatible with the 24-bit, 48 kHz digital files I create myself in digitizing vinyl LPs. I use this D to A converter to feed the coaxial SPDIF output from a hi-res audio player into the legacy analog monitoring system. I also have the reverse Analog to Digital Gefen converter going the opposite direction. Simple, inexpensive, and no audible latency when used with video. Using the A to D converter with the optical digital output also eliminates 60Hz hum that is common with a pile of components all interconnected. The D to A converter is also compatible with the 24-bit, 48 kHz digital files I create myself in digitizing vinyl LPs. I use the D to A converter to feed the coaxial SPDIF output from a hi-res audio player into the legacy analog monitoring system. In the midst of the high end hype that is common with digital audio devices, it is refreshing to find devices like these Gefen converters that work perfectly for such a low cost.

Started with the SpyderCHECKR 24 and it did a great job but the SpyderCHECKR with 48 color swatches is twice as good due to one simple fact, more info better color. We shot a lot of artwork for reproduction and this little gem works well and gives you a great starting point.

Love vlan with easy interface. Lots of YouTube videos with explanations. Solid, both 24 and 48 volt POE