3D Printer Bed Sticking Too Good

A really good 3d printer! The removable bed is so much easier to remove prints than my old finder! Remember you must first calibrate the extruder and then level the bed. I would do this twice! Also set the auto bed leveling on. After that it prints great!

As a first time 3D Printer owner, I found this equipment to be very user friendly and intuitive. I especially like the automatic bed leveling and 7" display features.

My first 3D printer and I love it. The instructions are clear and it is easy to assemble out of the box. There are a ton of youtube videos on this printer so this has helped me a lot. What I found most valuable is to make sure you FIRST mechanically flatten the bed and then do the auto-leveling. I do an auto-leveling before each print because every time I remove a previous print I fear it moves the adjustment. Remember we are printing ~0.12-0.2mm layer heights so I think it is important to auto-level each time. It only takes a minute or two. Also do it with the bed and nozzle at the temperature you are going to print at.

This filament prints at approximately 225 C on my printer. Running bed a 90 C. Getting good results and color. I will buy again when this spool gets low.

The printer was easy to set-up and came with thorough documentation. Dremel's website has support docs and videos online as well. The printer's fit and finish quality is good. 3D prints of my .stl models were excellent using the included Dremel filament. The 3D models included with the printer required a z-axis calibration first. It's an easy process and Dremel's phone support was very helpful. You print models from a USB flash drive, a network connection using Dremel's DigiLab PC software or their web Print Cloud solution. B&H's ordering process was easy and straight forward. Their pricing is good, even more so using their PayBoo card.

If you are using an Epson printer, you should also be using Epson paper. Too easy, results are great....

Too expensive !! I may purchase a different brand of printer nrxt time.

Good and like the brass frame over aluminum for sticking

Very good sticking power, removes cleanly.

I had a tripod that was sticking a little, a dab or two of this stuff and it is working good as new.