3D Prints Stick To Masking Tape

I'm tired of struggling with masking tape to hold up my backgrounds. This tape provides a strong hold.

We've been using rubber bands or masking tape to hold cables and connectors in place. These do a much better job and aren't wasteful either!

Suggestion. Use masking tape as wide as the protector for the hinge as that will provide more stability when you lay it on the LCD screen. Took a little bit to rub a small air bubble out so enough force with the provided cloth to do so pushing towards the edge(s) of the LCD screen.

I have three old lights that I use mainly for video work, but they were not compatible with my light stands so I had to use masking tape to attach them. I purchased these mounts because at the price I wasn't going to lose much if they didn't work out. They not only worked out, they fit perfectly into my reflectors and attached to my light stands with no problems.

It's my first roll, and I'm already ordering more in white. I never tried using this type of tape, I've always used automotive masking tape. This tape seems stickier, easier to tear, stays put once adhered, and removes cleanly with no damage. I wish I tried this tape sooner.

Great tape and it doesn't stick to things I don't want it to stick to.

You use it to stick things to other things...or you can use it to lash things to other things...sometimes you can even use it to keep light from something escaping. It's tape.

Stick better than duct tape and leave no residue in most situations.

This gaffer tape offers a good value. So, go ahead and stick it!

Comes with double sided tape to stick into the lid.