4000 Psi Pressure Washer Harbor Freight

This does fit with the knock off Harbor Freight version.

Hey, I know you can get cheap suction cups at Harbor Freight. I've done that. But then you waste time (and risk damage to underlying surface) in trying to tie stuff on to them. What you really need isthis. It's articulated, strong, and has the very stud you need for mounting virtually anything. As photos of these in use indicate, you want more than one. CLEAN the surface to near sterile before using on auto paint and monitor suction and you're golden.

I have a Harbor Freight Pelican look alike case. Whether you get the Pelican or the Apache (Harbor Freight brand) Case, the pick and pluck foam is terrible. It's really ok if you used it, broke it down and used a shipping material. The Trekpak is fully customizable and allows a bit more space in your case to store your belonings. Pretty intuitive but also instructions in YouTube to make it easy to use. Although a bit on the more expensive side, I will have to get for my other cases. It's totally worth it.

Yeah you could go to Harbor Freight and get a knockoff, but why? I had a Pelican with about $2K in gear inside fall out of my kayak when it tipped (due to waves from a sudden wind squall) and it just floated. Everything was dry inside.

In the past I usually went with the cheaper Harbor Freight cases, but went for the genuine Pelican for my recent kit. I can only say good things about the 1535 air. I think the most noteworthy is the weight and size for travel. I do wish that the foam had two levels of height for shorter items, but I was able to cut some foam to work as needed. So far the foam is holding up and not flaking or shedding. If you are looking to save money with a knock off...don't.

The A-MoDe Lid Organizer for Pelican 1510. I am actually using this on a Apache 5800 from Harbor Freight. I needed slightly fatter screws but it's working perfectly. Apply included adhesive tape to lid then attach organizer backer and screw in firmly. This holds my laptop and tablet with ease. Loops on front make cables and accessories easy to see and access. Laptop case and cable bag are held in place with velcro so you can remove or change orientation. I am very pleased so far and would recommend.

I use the tablet for small drawings. The 4000+pressure levels are fine enough to make the pen characteristic good to look at. New time i might get the one with blue tooth connector to avoid the extra cable on the table - no batteries for the pen is great - makes the pen fairly slim and avoids the need for new batteries. Still need to get used to the buttons.

I use it for movies and playstation 5. Both are amazing The white version goes well with my ps

Someone please tell me any other film washer better than this.

I checked PSI website for correct swab to clean my Nikon D500. They recommended the Type 3 - 24mm you use for full frame . Don't use it. The Type 3 - 17mm swab is the best one to use for a crop sensor. I had to use 3 swabs to get the sensor really clean. There also a magnifier with a light built in you can use to view the sensor. Definitely get it . So worth the $15