Air Conditioner Small Room With Remote Control

We have it for everything, Air-Conditioner panel control, Land line phone, Toys Etc',

small remote control, cheap and easy.

The Air remote is easy to use, offers full control of you Profoto Air equipped lights.

Small size, easy storage and carry for easy remote control.

The Air Remote goes on the hot shoe and, once firmware is updated, gives full control of the B1 lights from the camera. I like being able to control modeling flash and exposure control from the camera; obviously skipping a bunch of setting on each light. In simple parlance, the unit works exactly as it should.

This flash works great, it rotates, swivels, and covers a lot of area. I purchased this flash with the Air 1 commander, and they sync in less then 3 seconds. The flash has plenty of control capability, as well can be operated remotely, and it comes with a small stand, for impromptu remote flash photography. I am a novice photographer, but this flash makes my shots look great, by offering flash lighting control, so I dont over expose my photos, nor under exposed, and I dont have to keep repositioning the remote light source, because I can increase or decrease its flash power. I paired the flash with the Air 1 commander and on my Sony A7R ii and thus far, I have a realiable flash system that I can take anywhere.

The VRS-Lanc wired Remote Control, it was just perfect what I was looking for it!, it’s small remote Control, Cheap and works perfect on my Sony Video Camera!

The remote control is excellent, the flash about as small as you could make it and still have swivel and tilt

This is the perfect device for remote control, small, easy to install and easy to use

This control system is excellent. It works with Epson projectors out of the box, however I use all InFocus and it's remote learning functions make it simple to program and easy to use. You can have one of these up and running and controlling a projector in literally minutes (save the install and wiring of it, of course) It comes with several pieces you can switch out on the control surface for each of the three areas of control. Power, source select and volume up/down, to match your needs. It also has a blank panel if you are installing in a room that you want the users to have very little control other than on and off. It glows a nice blue color for easy use in a dim or dark room, fits in a single gang box which can be mounted on the exterior of the wall with cable raceway for the easiest possible installation (you don't event have to cut thru walls!) Just make sure if you use the IR with remote learning and you don't have an epson, that your projectors remote control has the functions you want the panel to have. you can only program the panel to do things the remote control has buttons for....