Amd Based Desktop Computers

AMD has finally, and fully, eclipsed Intel's performance in desktop PCs

I built an Asus based machine on 2012 for myself among several other builds over the years. My Asus machine with an AMD Phenom Black Edition was still going strong until mostly out of desire, not necessity I built my new machine. I have always believed in Asus products. My new board is well constructed and easy on the eyes. I have an AMD Ryzen 7800, 2X16Gb GSkill memory running stock at 4800Ghz and a Crucial T500 M.2 Flash drive. Coolers, case 850W PSU etc.. This system went together easily. Everything is so clean in design now. I fired it up, installed Windows 11 and just got to it without a single flaw. Updates were fast and easy and I've not had a single issue. Performance is great, temps are good, hardware is beautiful and the software just works.

keep going, AMD!

quality label output, works on network (but install is tedious) but not with ARM based windows computers, software is overly complex

I use the Arc Mouse for my desktop, laptop and netbook computers. Very easy to use and the design makes it very comfortable to use. It takes just a little adjustment after switching from an optical mouse, but you will not go back.

I know that there are several companies out there who make good memory cards, but when I check my stash of memory cards, most of them say SanDisk on them. Likewise, most of the back-up memory for my Desktop computers say Western Digital (who owns SanDisk). My advice is to learn about the nuances of memory cards. The small print on similar looking cards distinguishes the capability, not just in GB capacity, but the generation of chip and the speed for reading and downloading. I also own some Sony and Delkin memory cards, but SanDisk makes good stuff.

Both dives allow me to easily transfer files from my laptop to my desktop computers. I find it very easy to use.

Short review: I wanted to find a USB switcher I didn't have to worry (or even think) about at all. This is it. Long review: for context for the rest of this review, my use case is to switch a common set of USB devices (keyboard, mouse, and USB audio device) between a desktop and a laptop. I bought this unit after having a poor experience with a much cheaper USB sharing switch from another manufacturer. This other unit lasted about two years, then started to fail to switch between host computers, and also seemed to be allowing voltage from one host to pass through to the other. I'm not one to risk damage to the valuable computers I've got hooked up to these switches. I got rid of that unit, did some research, and picked this one up based on some other folks' recommendations. This unit isn't cheap, and seems to be marketed primarily toward business use cases, but so far it's working perfectly for my home office setup. It appears that I'm getting exactly what I hoped I was paying for: reliability and safety. I haven't had a single electrical gremlin show up since I began using this. It automatically switches the three USB devices to my laptop when I plug it in, and switches back to the desktop when I unplug my laptop. I'd recommend reading the instructions and making use of the power supply.

I purchased this cable to connect a desktop to an Anker USB hub which is routinely switched between one of three computers, depending on which is needed at the time. The included Anker cable is about a foot long, which is far too short to reach the desktop. This helped bridge the gap and works perfectly.

Sharing a desktop extension monitor between two computers meant unplugging from one and plugging into the other. Now I have the computers plugged into the switch and the switch output goes to the monitor. Now I just push a button! The switch even automatically switches to the live computer if I turn one of them off.