Among Us Switch Pro Controller

Used it with my UDM PRO to connect to my US‑8‑150W switch. Be sure to set the UDM PRO SFP to Link at 1Gbs FDX in order to work.

The switch was quickly adopted by the controller and was up and running in a few minutes.

These were a quick drop & replace over my old US-AC-LITEs. The controller *does* ignore the radio settings from the old APs, though, so make sure to change your channels back to defined ones / disable 5GHz DFS channels if you have old devices that are picky.

Makes using controller software simple as plugging into switch

My Ubiquiti controller adopted and updated the switch perfectly.

I have this being powered from a UniFi US-16 150w POE switch and powering a UniFi AP-AC-Pro access point through the POE pass-through port.

My first US-8-60W switch has been working 24/7 since 2017. Very reliable, small, but yes it runs warm. My network has been expanding and I needed another POE switch. I went with what I know is reliable.

The US-8 is a very compact and light switch, but don't let that fool you. Some of it's features include the ability to be powered by POE (no need for a local power outlet at the switch), and the presence of a POE pass-through port to further extend power to an additional POE powered device. Beyond this, the switch is fully manageable, not a dumb switch like most consumer/small business switches. It is a wonderful and dependable switch on any network, but reaches it's full potential when part of a Ubiquiti Unifi gateway. This is a great little managed switch for the price. Actually great regardless of the price - buy it!

The one I purchased is being powered via PoE from a US-8 switch. I love unifi, it's comparable to being "the apple" of networking. The system is incredibly reliable. You can set it and forget it if you like, set it up, close all the software and it will continue to run with current instructions. Before moving all unifi I had an AP Lite wired into my older linksys router. It never went down, never slowed down, I hadn't needed to restart it in about 16 months.

I purchased the following to replace 2 consumer grade routers. I have a Linksys WRT54G that is probably 10 years old. It was running the dd-wrt software. It's been great, but I figured it was time to upgrade. I purchased a Linksys� Max-Stream AC2200 first. It wasn't good. It needed frequent power bounces and on one occasion it completely lost the configuration. Its wireless interface was failing all the time. Very sad for $200. I returned it and reinstalled the 54G. I stumbled upon Ubiquiti and glad I did. Setup wasn't difficult, but I'm an IT guy. After a couple of hours, everything is working fine. I expect that to continue. I'll let you know if otherwise. Range of this AP is much better. I have a 2400 sq ft house on 2 levels and this covers the entire house. It reaches out to the front yard and the Linksys never did. I purchased a console cable from Amazon. (USB Console Cable USB to RJ45 Cable, labeled Moyina) I didn't need it because everything was done via direct connection (router) or the controller software (WAP and Switch). -US-8-60W UniFi 8-Port Gigabit PoE Managed Switch -UAP-AC-LR-US 802.11ac -ERLite-3 EdgeMax EdgeRouter Lite 3-Port Router