Android Phone Factory Reset On Same Device

I used to travel often and used the RavPower, however, most of the time it will not see any wifi networks unless you factory reset the device. My initial tests at home with the tplink 902AC saw much better visibilty of all wifi networks and once I figured out the odd menus had it up and running. it runs off a portable phone charger so can work in a coffee shop. So far so good. the real test will come when I get it to a hotel and see if it can see the wifi networks.

Purchased a used model. Everything but the power cord was inside the box. Luckily, I had a spare so no issue turning it on, but when I did the User/Password screen appeared instead of the Activation screen. The device was not obviously not reset to factory settings before repackaging. Went to Youtube (University) and found reset button is supposedly mounted on the board inside. Found it after removing the screws and cover. Pressed continuously for 30 seconds until one beep sounded. Released the button and after several minutes the Activation screen popped up on my SmartTV connected via hdmi cable to the NVR. Thereafter used the browser GUI interface to complete the setup. The device takes longer to start up compared to an older EV1 model, which has been running with no issues for the past five years. Also purchased a used HIK 8mp POE bullet camera model ds-2cd2083g2-iu which has stunning clarity and color. Takes time to sync with the NVR on startup but well worth the wait. Reported the factory reset issue to B&H. Saved half the cost, compared to buying new. Only minor blemishes on the outside. All good on the inside. HIK's iPhone app (iVMS4500) is the best there is for remote viewing. Others simply don't compare in ease of use.

failed first install did a factory reset everything is fine

I'm a HUGE fan of this device....especially when used with an Android phone, which all you need is a USB A to C adapter for. If you wanna do videos or podcasts with great audio on the go...without bringing a computer...this is the way to go. Will this drive an sm7b? No....no it won't...but most dynamics it will...condensers, no problem. I just snap a klark teknik ct1 onto this thing for sm7b use...still ultra portable, and the price of both is just over a hundo. For the record....I've owned TWO Shure x2u devices....both went bad. Go with this for ultra portability. [I received this product in exchange for my honest review.]

...once I figured it out. It needed to be reset to factory settings, but once done, all works as---or better than---expected. THANKS

[This review was collected as part of a promotion.] I use this device to connect my android phone to my projector. It does the job and has minimal latency. I am not sure about 4K resolution because I guess it was originally made to connect a laptop to a projector. 

My expectations for a $ Peavey product were very low, but this device just works, and it works well. I have used it on my Sony Xperia Android phone, various pc's, and a couple macs and it performed very well. This is the most cost effective way to get balanced audio from your various devices, with good sound quality.

Store/move files around/between Android phone, PC/USB A device. I am unaware if usable with new Iphone C port. A little unweildy as A vs C ports swivel. May get hot.

Good modem...a little difficult to setup (must reboot several times, and set to factory reset a couple of times) to obtain the IP address. Once that is obtained, then just works.

Fast delivery and easy set up... if there is an issue, just factory reset and it works no problem. Great product