Anycubic Photon Sla Dlp 3D Resin Printer

The Cinegel UV sheets are perfect for protecting 3D printer resin from sunlight coming through the window, without losing the light for the room.

This is an excellent 3D projector. There is absolutely, no cross-talk and no flicker at all, even with material that is not very well known for its 3D quality, such as Tangled, or Despicable me and Monsters vs Alliens blu ray 3D! It delivers very bright and perfect colour saturation even in daylight conditions in the projection room with very low noise! I saw no judder at all, even in very fast action scenes! The only problem is with its set-up, since there is luck of vertical, or horizontal lense shift! However, with a little effort, this is a disadvantage which can be overcome! DLP technology from Texas Instruments, and 3D-RF, or DLP-Link technology developed by Optoma, really deliver the great performance results, Optoma claims for these technologies to perform in its official site! ...And all this at a fraction of the cost other 3D projectors have! I'm off to getting the upcoming Optoma HD83 model for sure, especially if it sells at such low a price as the HD33 model!

Use it to clean mirrors off an SLA printer, works nice.

This resin works really well with my printer using the recommended settings

This printer has been around a year or so and the firmware updates are great and simple to preform. It is a solid(resin) preformer. Got it on sale and I do not see a better printer for the money. Uses open source software so you are not locked into any eco system. Any issues some have had in the past are fixed with the firmware updates. Mechanicaly sound and quiet. The wifi is a great addition; no usb sticks or cable needed.

Excellent choice in photon paper. Comes out looking as good or better than professional service.

Great filament for an xyz 3d printer. Had trouble finding filament for my specific printer but found it here.

Uh, my friend just adores this grip. He says it allows him to form a photon cannon which serves as a powerful light source.

I have several small flashlights for different keychains, etc., ie. photon. It is a little longer than most but puts out a bright light and is still small enough to not be a bother. I have not had to change the batteries yet so I can't speak about that.

This was my first 3D printer! It was an easy setup. It took me less than 45min to build plus the set up time. It’s also user friendly! I would highly recommend this as a first or additional printer!