Apc Backup 600 Manual

Works with my APC Backup..

My APC Backup unit told me through the main unit that it had a low battery for the backup unit by a red lit signal that went off every 4 seconds. I had to replace the battery to stop the beeping. When it arrived, it was well packed and had a return label for the waste disposal of the old battery. The installation of the new battery was not as difficult as getting the old battery out of the unit - it was a very tight fit. Now that it is installed, the beeping stopped and life is back to normal. YEAH!

OEM battery fit perfectly into APC Backup & operated per design.

Great replacement for my APC Back-UPS 600. My model is a BN60G, which was not listed in the #17's supported models, but it has worked perfectly for the last couple weeks. The replacement arrived very quickly and was very easy to swap with the original battery, allowing me to get back up in no time.

I replaced an APC Back-Up 600 with this CyberPower 1000. I build my own PCs and recently did a major upgrade. The APC unit was over 5 years old and showing signs of needing batteries. It was also intolerant of the new 850 watt Corsair power supply. My new PC would quit and reboot every time there was a power glitch. I needed a new UPS unit that suppiled pure sine-wave power. The APC unit only delivered square wave simulated AC power. The only negative is that the utility softare is not as smart as the APC product. You can't tell it when (while you are sleeping) not to sound the alarm.

Finding the correct replacement battery for my relatively old APC Back-UPS 600 was straightforward with B&H. Installation was no problem. I watched the videos but that would not be necessary because the procedure is as simple as changing almost any other battery. (The original battery lasted 8 years)!

This was the second replacement for my APC Backup. Very easy to install ( 30 seconds). Priced just right.

My APC battery backup died. For a fraction of a new unit B&H shipped me the new battery to get me back running.

Been over 3 years now , out of warranty . needed new battery . Read user paper manual page 8 ,...Battery is replaceable , Page 8 implies APC does NOT recommend the End Consumer to do it . Instead , page 8 recommends an SEIT Service Center to replace the battery . The paper user manual says to take the unit to a Service Center for battery replacement , NOT to a recycle center . Please , read the manual . APC may or may not approve , but i just dropped in a CSB GP 1272 F2 7.2 ah battery. BN450M is better then ever at near 200 watt load . BN450M delivers the goods at 200 watts , when paired with a proper battery . Purchase strategy : If you have No ups , then get the BE650G1 as it comes with a 9 ah RBC17 battery Which will easily run 200 watt loads . If your BN450M is now out of warranty , I recommend replacing the battery at your discretion . If i knew what i now know , i would have gone for the BE650G1 ( to get that larger battery )

This replacement battery for my APC power conditioner and battery backup is exactly as the original OEM battery. Delivery was prompt and arrived as estimated. I highly recommend B&H.