Bass Amp Simulator Pedal

Used once for powering guitar amp, powered monitor, pedal board, and bass amp on stage. Performed well and kept the hums at bay. Long cord legnth and good plug access.

I am building a flight simulator and used it to amp up my headset worked great.

I bought a pair of these to use with a guitar amp simulator. They sound great and allow for getting the amplifier and effects tone without having to crank up the volume to concert levels.

Use item to connect guitar amp pedal controller. Good length to free up on stage movement.

I purchased the Xvive wireless guitar system based on a number of positive YouTube reviews. I figured for the price that it would be worth it if I could get it to work. I first tried it by inserting the transmitter into my PRS and the received into my Mesa Boogie amp directly. Worked perfectly. I didn't mess around with selecting a channel so I suppose it just worked with the default selection. I next plugged the receiver into an overdrive pedal and the pedal was plugged in with a cable to the amp. Again it worked like a charm and there was no noticeable difference compared to using the pedal and amp with a cable. Later on I did play around with selecting a different channel on the transmitter. It takes a little getting used to, but the device beeps the 1-4 times depending on what channel it's on. You have to set the receiver to the same channel to get the system to work. There is no light to tell you that the two are on the same channel so you just have to keep pressing the channel button to get them to sync. Anyway, if you don't have a second guitar using the same wireless system it's best just to leave it in channel 1 and leave it alone. It will work well. While playing I moved around the house and it definitely has great range. It was fun moving into different parts of the house without worrying about getting tangled up in a long guitar cable.

My problem as a guitarist is how to carry less gear (no amp) and produce a sound that will still have that super clean sonic characteristic similar to my mesa, replate, or two-rock, amps. I use a TC Electronic Nova System for all my pedal needs (it is a monster plus Pete Thorn uses it). The Nova can go directly into the ToneMatch as long as I dial in a ToneMatch sound simulation built into the tonematch. (there are some great varieties to color the sonic possibilities (such as: Miked Amp w SM-57)). The tone was gig-worthy but a bit sterile. (no tubes in the chain) The final component, an Effectrode Blackbird pre-amp pedal with a 600 ohm direct out (dead silent). The Blackbird provided the missing piece. With a 3 tube preamp design in a medium-small pedal, it's provides an astounding tube warmth. Guitar-Nova System-Effectrode Blackbird-Bose ToneMatch-L1 Model II with B2. Plus much easier to pack to gigs. My band switched from a pro-grade JBL SRX PA with QSC amps to two (2) L1 Model 2 with B2 bass sub units.

I use this for storing my micro bass amplifier and pedal tuner. With the multi-level foam there is a lot of room for adaptability. I have nothing bad to say about it thus far!

I purchased this foot pedal to pause a youtube clip as I try to play along to bass tablature. This works perfectly for this purpose. Much better to use a foot pedal than to stop playing each time I needed to pause the youtube video. Quite simple to set up, and the online support is top-notch to boot.

Flight Simulator

Using this for bass amp. Have an Ampeg SVT Pro pre-amp running into it. Using it bridged.