Belkin Bluetooth Receiver Reset

Very good Bluetooth receiver.

Great sounding receiver ....AWESOME with my Bluetooth

I bought this receiver for the Bluetooth connectivity. I am now able to play my iTunes songs from the iTunes cloud through my iPhone and the new Receiver to our inside and / or outside speakers - all from my lounge chair. I am handicapped, so this is of great help to me.

I previously wrote a three star review because I couldn't get the app to see the tubes, after some investigating, you must reset the bluetooth on the tube light itself. Do this by pressing and holding all three buttons until the tube blinks blue. After that, I could get the app to see all four. So perhaps when you get them, first thing you do is reset the bluetooth on all four and you will save yourself a few hours of frustration!

I have not had to reset like I did with the other one

Great receiver for garage or man cave Bluetooth setup

One of the best systems out there. It works perfectly and I would recommend it to anyone looking for a great Bluetooth receiver

[This review was collected as part of a promotion.] The Belkin Soundform Connect adapter is a nice little tool to convert a non wifi, non airplay device into one that you can stream music over via your phone or other device.  I have an old receiver and amp wired to older but very high quality speakers throughout my house.  Previously I would just play the radio or CDs, which of course no one does anymore!  So I got the Belkin Airplay 2 device and now my older system is so much better!  I simply plugged the Airplay device into my receiver using the digital optical out, which is a great feature not found on many devices like this. Note...the optical cable is not included. I like the small size and quality, and have always been pleased with Belkin products, and would recommend. 

Very straightforward 2 ch receiver with bluetooth and a turntable pre. Respectable power output... Clean looks... and, it's a SONY!

This receiver has revitalized my 1980s stereo system by allowing Bluetooth transfer from my Sony Walkman (CD quality) and from an iPhone. When powered the receiver goes into pairing mode--your device remembers this receiver...you are connected. So far there has been no problem with connection or distance from the receiver. As this is my second unit (first attached to another stereo system) I only wish I could rename the unit as it comes up with the same name...only to be identified by the Bluetooth address. If you only have one of these, this will not be an issue. Attachment is simple: connect using RCA supplied cord to your receiver aux input. Having it on a switched plug on the receiver is very convenient. If not, you would have to push the light button to switch it into on mode. It has an auto off after a few minutes of not receiving a signal. It also has an optical connection.