Best Disk Cloning Software

You need this, a new drive and disk cloning software (usually free) if you are upgrading your computer HDD and or SDD.

The cloning and software for these drives is the best! I've never had any issues yet.

Best flash disk

Cloning this 4TB beast was a bit painful, mainly because I had 4 disk partitions already on my old HDD and tough to go from MBR to GPT with that setup. In the end, I just saved my Windows license, Office license keys and did a fresh install of Windows 10. Went very smooth, needed to update audio drivers to overcome this new crackling, whining sound that became worse after the SSD install. Laptop reboot and disk access is now lightning fast even with my 5 years old laptop. All in all, its a keeper!

I have cloned drives from Crucial and Samsung. Samsung comes with the best cloning software. I put the new Samsung 850 PRO into a slot on my Desktop, initiated the clone from a suspected under performing Crucial SSD. The Cloning failed due to a bad sector on the Crucial SSD. The Samsung cloning software walked me thorough the correcting steps. All I had to do was click 'YES' as it took me 'by the hand' through the fix. The cloning software re-booted and again the cloning was initiated. Around 1 hour afterwards, the cloning complete, I disconnected the Cruicial. The Samsung 850 PRO has been working flawlessly for the week. I'm sold!!!!!!

I was initially hesitant to use a cloning device without software. But this cloning station worked flawlessly and much faster than I imagined. Great product.

Bought this to UG my desktop boot HD. I used the free cloning software and installed it, first time booted right away (lighting fast) easiest upgrade I have ever done!

Product is good and works as intended. The issue I had is my fault for not researching better. I purchased a Crucial SSD to replace laptop spinning hard drive. The free Acronis cloning software from Crucial requires a Crucial drive to be seen in the system. The software saw Sabrent attached drive and not the Crucial drive in it I wanted to clone to. After using a different free cloning software I was successful. This is no fault of the product and I am quite happy with the external drive. The on/off switch is handy and the drive comes with a 30ish inch (aprox 76cm) Type A connector USB cable. The case is plastic and the cover slides off. No tools are required. The case has an internal rubber sponge pad to keep the drive pushed forward into the contacts. I wasn't comfortable with the force required and the angle of insertion. If you use something to push back and hold the pad during installation, the drive drops right in and slides easily into the connector. Considering the cost of the product I think this is non-issue, just something to be aware of. The pad holds the drive firmly in place.

Samsung software worked well for cloning drive. Huge performance gain on Alienware R4 desktop.

Glad I bought this SSD instead of a new laptop. Samsung cloning software worked beautifully. What a performance upgrade!