Black And Decker Refrigerator Parts

I bought this bad to carry my Black & Decker Battery Powered Laser Level. It was the perfect bag.

our refrigerator is covered with them!

Have a high end refrigerator that is plug in into it, so far so good!

Even better than promised. Will try hooking it to my refrigerator.

Strong enough to hold up a refrigerator, I think. Fits perfectly, of course.

Connected to my River, kept my portable refrigerator going all weekend

I like the feel of all knobs and parts of this, it gives me confidence that it will support whatever I need. I like the all black finish - I hope it will hold up well to transport and normal wear.

This is perfect, for small black parts. Can put this on a table top and work easily without breaking your back.

Although Atlas mic stands are no longer domestically produced, they are still a quality stand. The 10 cast iron base has the same threading as used in the mid-height stand, and the 7 adjustable desk stand. That allows one to use the standard low profile 10 base with an adjustable short column for mic'ing kick drums or to place on the dolly of a grand piano without fear of being easily tipped or knocked over. I note that replacement parts for the clutch are available, and the parts fit even decades-old Atlas stands. While the ebony (black) finish on the shaft can get a bit scuffed from rough handling, I generally prefer the non-reflective black finish to the reflective chrome plating that is available on the MS-12C version of the stand.

I like the plastic see through pouches. tight but perfect for cables and small parts. The heavier duty black pouch has a bit of padding and works well for bulkier items. These will last well.