Bluetooth Antenna For Marantz Receivers

Bluetooth works great is made to hook up to receivers with no pre amp

This antenna paired with a Shure UA844+SWB and a pair of Sennheiser EW-DX receivers for four channels of wireless mics. Reception from the RF Venue Diversity Fin is exceptional and provided dropout free performance where the antenna was indoors pointed toward and outdoor Wedding Ceremony location - line of sight through glass/walls at about 100 feet with two lav transmitters in groom and officiant's pockets and a EW-DX handheld on a stand. Not ideal re lav placement but very typical. Signal received strength was almost 4/5 or full bars as indicated on the EW-DX receivers with a 10mw output. I like this over the Shure LDPA's since I can place this on a tall weighted base mic stand vs other antenna / stand combinations. This setup is SOLID! I would buy this antenna again.

I had 3 sets of Sennheiser's wireless Microphone that were still working, but the intallation along the antennas was cracked and peeling away exposing the antenna itself. So I did a search on YouTube and found it you can replace them antenna it wasn't a hard job to do. In fact I had to order a soldering iron because this is something that I usually doesn't do. I know I had to get antenna repair because I was getting dropouts since I replace the antennas the receivers and transmitters work that flawless. I knew if I had to send the transmitters and receivers into Sennheiser I would had to wait for the transmitter receivers to return which I use them almost on a daily basis. I highly recommend it if you have a Wireless set that need new antennas within this frequency range you can rest assured that they will work even if you have to send to a local repair and time and cost.

I own 2 of these, one holds 4 Shure ULXP receivers with the antenna/ power disto and the other holds a Behringer S32 Digital Snake I/O Box perfectly (should be listed on the S32 page because it fits so well...)

This kit is solid. I used it to mount two receivers side by side. Make sure you purchase the Sennheiser BNC Antenna Cables (extenders) to go along with the kit.

If, like many of us, you use G3/G4 ew100 systems as wireless camera hops, this is a must-have. Since the receivers use the output cable as a second antenna, it’s important that the cable be rugged and reliable, and the stock cable from Sennheiser isn’t the greatest. This cable is the best inexpensive system upgrade out there. A sturdy, metal locking 3.5mm connector promises to hold up during regular on-set abuse. The low-profile XLR connector also avoids bulk when placing camera gak, and allows the cable to nestle into a camera rig. And if using the G3/G4 receivers in a sound bag, the same benefits apply. Better performance from the cable as a second antenna, sturdy construction, easy to run the cable through the bag, and a low-profile XLR that keeps the side of the mixer recorder clean and tidy.

I purchased two different (and much cheaper) Bluetooth receivers prior to the B1. �Both would cut out again and again even when my iPhone 8+ was only a foot or two away from the unit. �The B1 has not failed me once and it works as far away as the upstairs floor above the unit. �No drawbacks that I can see other than some audio quality loss at louder volumes. �Highly recommend.

This paired easy with my Samsung S8 phone. It has much better sound quality than other bluetooth receivers i have used. It has great range too. My only conplaint is that the holes in the rack ears are too small for #10 screws so I had to drill them bigger to get it mounted in the rack.

I've had a number of Bluetooth receivers over the years. They have all suffered from limited range, frequent dropouts and pretty mediocre audio. The B1, has eliminated these problems. Range is superb for a Bluetooth device and the audio response is superior to anything else out there. An added bonus: most Bluetooth receivers lack the output to drive my SET and push-pull tube amps to there fullest. That is not an issue here, plenty of clean, noise-free output! Plus, this box is built to last, no cheap plastic enclosure here. A welcome addition to my audio lineup!

This has become my favorite keyboard because of the feel of the keyboard itself, the sculpted keys, smart backlight and effortless Bluetooth connectivity. Switching between up to three systems is effortless. Paired with the MX Master 3 mouse, I am saving desk space, I don't need USB ports to plug in receivers and lost or mismatched receivers are a thing of the past. No more batteries eventually leaking electrolytes into my devices since this keyboard can be recharged.