Bluetooth Stereo Receivers 7.2

Bluetooth works great is made to hook up to receivers with no pre amp

Long enough to connect to your non Bluetooth devices! Well made 1/8 stereo connector!

Use these for running lavs receivers into a mixer/recorder. No problems, but you have to be aware that it doesnt work for some devices depending on mono/stereo issues. For example this doesnt work to run a Sennheiser G4 RX unit into a single XLR input- that requires a stereo mini to split XLR channels.

Perfect replacement chord for some stereo receivers; in my case an RS 700 Yamaha receiver. Also works for some Fender guitar amplifiers. Did the job perfectly.

I purchased two different (and much cheaper) Bluetooth receivers prior to the B1. �Both would cut out again and again even when my iPhone 8+ was only a foot or two away from the unit. �The B1 has not failed me once and it works as far away as the upstairs floor above the unit. �No drawbacks that I can see other than some audio quality loss at louder volumes. �Highly recommend.

This paired easy with my Samsung S8 phone. It has much better sound quality than other bluetooth receivers i have used. It has great range too. My only conplaint is that the holes in the rack ears are too small for #10 screws so I had to drill them bigger to get it mounted in the rack.

I've had a number of Bluetooth receivers over the years. They have all suffered from limited range, frequent dropouts and pretty mediocre audio. The B1, has eliminated these problems. Range is superb for a Bluetooth device and the audio response is superior to anything else out there. An added bonus: most Bluetooth receivers lack the output to drive my SET and push-pull tube amps to there fullest. That is not an issue here, plenty of clean, noise-free output! Plus, this box is built to last, no cheap plastic enclosure here. A welcome addition to my audio lineup!

This has become my favorite keyboard because of the feel of the keyboard itself, the sculpted keys, smart backlight and effortless Bluetooth connectivity. Switching between up to three systems is effortless. Paired with the MX Master 3 mouse, I am saving desk space, I don't need USB ports to plug in receivers and lost or mismatched receivers are a thing of the past. No more batteries eventually leaking electrolytes into my devices since this keyboard can be recharged.

This receiver has revitalized my 1980s stereo system by allowing Bluetooth transfer from my Sony Walkman (CD quality) and from an iPhone. When powered the receiver goes into pairing mode--your device remembers this receiver...you are connected. So far there has been no problem with connection or distance from the receiver. As this is my second unit (first attached to another stereo system) I only wish I could rename the unit as it comes up with the same name...only to be identified by the Bluetooth address. If you only have one of these, this will not be an issue. Attachment is simple: connect using RCA supplied cord to your receiver aux input. Having it on a switched plug on the receiver is very convenient. If not, you would have to push the light button to switch it into on mode. It has an auto off after a few minutes of not receiving a signal. It also has an optical connection.

is wonderful for bluetooth transmission of iphone over home stereo system....remote controling of audio content to stereo