Bytech 6Ft Micro Usb Cable With Led Lights

The USB cable is about 2m (6ft); I wish it was a bit longer (eg, 3m).

Needed this for charging from a micro-USB cable. Works great for that.

I have another review that I wrote about this mic, but B&H's website doesn't appear to let me update that review. I've now been using this mic almost daily for over a year. The audio is crisp and clear, background noise is kept to a minimum, and people on the other end of the meeting/phone call give compliments on the detail that this mic captures. I used to use a condenser mic, but that also had the annoying feature of picking up a lot of 60Hz hum. This mic doesn't do that and I didn't have to make any adjustments to the room either. For the person who mentioned they couldn't fit it in a shockmount, it has one internally. That is why the mic is the size that it is. For those complaining about the USB port, mine hasn't had any issues. I accidentally bent the micro usb connector on the cheap cable they shipped with it and the mic survived just fine. The cable, on the other hand, was useless after that. I solved this problem by finding a 90 degree USB adapter so that the connector isn't pointing straight out the back of the mic. It now sits mostly flush and swiveling the mic is more likely to cause the adapter to disconnect at the other end. If your laptop, like mine, is usb-c only, don't try to buy long usb-c to usb-c cables. They are crazy expensive. Instead, try to buy a usb-c to mini or micro usb-b cable. They are much cheaper. My setup is usb-c to micro usb (10 feet), then an adapter from micro-usb to usb-c (1 inch), and then finally a short usb-c to 90 degree micro-usb adapter (6 inches).

The Lexar 3.1 Reader has worked reliably every day for the last few months. It seems to allow nearly full read & write speed of v30 and v60 SDXC cards when connected to a USB-C port with an adapter and also works as expected on USB 3 Type-A ports. The bright indicator LED changes from red to blue when a card is mounted. Insertion and removal of SD cars is smooth and easy with no scratching of card contacts. I don't use micro SD cards, so haven't tried the micro SD slot yet. Idle current for the LED and interface chip is a low 31.4 mA (no card inserted) and the reader stays cool during extended use. Seems to be a reliable card interface at a reasonable price.

Buy a longer cord like the USB 3.0 A/ML to MICRO B/ML CABLE - 3'

I have been using 4 of these batteries to power my LED lights during events, they have been workhorse for the number of times I have charged and recharged them. I have noticed that these don't charge well when you use a lower wattage USB-c ports, what I use is the 65W GaN USB-c charger to charge these battery blocks. I know people have said that they have had bad experience with these batteries but I find these to be amazing for the amount of time I have put these to use. Currently using them to power following LED lights ( Fiilex P3 LED / Lupo 700 / Zhiyun P100c) For Fiilex please use their proprietary dtap to male pin ... for Lupo you can use USB-a to USB-C ... for Zhiyun USC-c to USB-c ... this battery supports all these connectors which is amazing to have.

Sadly, regular micro USB chargers dont work with the lights. These will do the trick!

Great product that replaces my old NU32 (micro USB) and now everything charges via USB-C. I like the lights and intensity. Overall well built and lightweight enough to be bearable over time.

The cable is well made, not flimsy. The USB & micro USB plugs plugged in smoothly with no struggle. Recommended.

By far the best and most reliable USB to Micro-B cable I've found. Frustration takes a back seat to quality.