Car Audio Amplifier Wiring Diagram

Took some research to make sure it was compatible, found the right wiring diagram. Installation was easy. Works as advertised. Highly recommended.

Simple set up. Easy to use. Works well with both direct wiring to an amplifier and via Bluetooth to a Smart Home speaker.

Even though I have experimented with stereo systems for almost 50 years, I had never bi-wired speakers until I recently purchased Bowers & Wilkins 603 floor-standing speakers. I was intrigued by their bi-wiring option that Crutchfield suggested could provide noticeable improvements in the overall transparency of your loudspeakers if I ran separate speaker wires to the low and high frequency drivers from a single amplifier. After doing some research, I discovered the Canare 4S11 bi-wire speaker cable at B&H. I don't claim to have golden ears, but I do want better sound at a reasonable price, so the Canare cables were interesting. However, I have to admit that to my eyes they looked sort of flimsy in the online picture, so I debated with myself about spending over $130 for two sets of 10-foot cables. Therefore, I was thrilled to discover that the two runs I ordered are not only substantial in diameter, they are professionally terminated with high quality banana cables that give me a tight fit into my vintage Audible Illusions S120 amplifier and my new B&Ws. While I can't tell you that the heavens opened and angelic choirs sang when I plugged them in, the speakers sound wonderful and I am now looking at upstream improvements in my system, including the RME ADA-2 DAC FS. My conclusion is that it only makes sense to bi-wire speakers if the speaker designer provides the option. So for me this was a great purchase. If you have speakers that offer the bi-wiring option, I highly recommending giving these a look.

With this cable, you don’t need to do the hard wiring for the cam setup. However, you will have to eject the cable when you need to do other diagnostics for the car or if you want to install some harness. This cable supports parking surveillance

Sold my car and did not have time to uninstall my wiring. However, I was able to reorder and install it in our new vehicle. Thinkware sent these to me and back on track.

Well made, exactly what I needed for my Crown Audio XLC 2800 Amplifier.

Thanks cardioid diagram, I have much less outside sounds and noise.

I've had Sony players in the past. I've also used bluray players as transports. My car cd player does a good job and I've never had problems with loading or unloading through its slot load system. But when I purchased a new amplifier and speakers, I wanted to make sure I was getting the most from my cd collection. After reading a few reviews, I decided to go all in on this unit. I'm glad I did. It is the most silent transport I've ever had. It is a sturdy case, which helps avoid jars and jumps. The music that comes from it is clear and the soundstage is wide. It makes the most of the recordings and the NAD C328 amplifier, which is what one desires from a transport.

Shoutout to salesperson Lee from Audio for explaining the benefits of choosing the correct wiring for my home studio to optimize my output. I couldn't be more thrilled. Thanks B&H!!!

Great way to clean up all the wiring in the back of your unit and get clean power as well. Just make sure to ground it if you're running audio to eliminate/reduce that 60Hz hum.