Cheap Cat6 Ethernet Cable

I like the white cat6 cable.

This is the cheapest SFP+ switch (but reliable) I could find for my homelab. Many others are more expensive. After reading reviews on the Mikrotik SFP+ options I decided to stay with Unifi since I already had many Ubiquiti Ethernet switches and a controller in place. I am also connecting this to a Unifi 24-port via 1-Gb SFP as a link and connecting to my core switch via 10GbE over CAT6. Core switch is an FS.COM unit with a 10GbE Ethernet transceiver. No issues negotiating to 10GbE. The CAT6 cable run is probably under 50 feet. I am also using old Finisar transceivers without issue, but have not tried DAC cables yet. However, if you do not have a Unifi Controller in place perhaps wait for the new QNAP managed combo switches coming out. It will be a lot simpler. Or you can get the more expensive EdgeSwitch ES-16-XG.

Not much to say about an ethernet cable, except that it works.

This is by far the best non-Ethernet home networking solution on the market delivering near 1G Ethernet speeds.� There were some teething issues for me that I had to resolve, but since then my three adapters have been rock solid.� So much so I just bought 2 more. A few tech notes from the issues I had to resolve.� High frequency bandwidth is everything for these adapters.� Make sure you have RG6 wires, this should not be an issue if using cable wiring preinstalled in the last 30-40 years or more recently by the cable company.� In my case the in wall wiring was OK with RG6 cable.� However a previous owner had used cheap R59 jumpers (with cheap twist on terminations) between a rat's nest of cheap Radio Shack splitters that couldn't pass more than 1 GHz.� I bought a higher quality 6-way splitter rated up to 2 GHz.� I also found that having a filter designed to contain the MOCA signals within the house was an absolute necessity.� This filter is installed at the input to the splitter for me.� I think the filter either addressed a high frequency impedance issue or controlled signal reflections that were causing issues.�� As an aside to anyone who cares, these adapters do pass VLANs and probably any other Ethernet L2 items like jumbo frames and the like.� I believe all MOCA adapters do is to encapsulate Ethernet frames and seamlessly pass it over the MOCA network.

Great Syandard Ethernet Cable. i uaed to buy audioquest items, found that theres no actual upgrade to that to a cheap cable. this is more than enough. buy pearstone great company

Excellent extender. I prefer to use this wiht CAT6 cable

Short Ethernet cable that works.

Ethernet cable wet dream.

A Ethernet cable that works! And it was low cost.

I use this cable at direct connection to my cable modem...Cat6 cables always work better than Cat5e..And this one has the maximum performance i need...