China Brands Thermal Printer Packaging Box

The packaging box was flattened, but the product was safe and worked well for my printer.

Genuine ink that works right out of the box. With off brands you have to work with your printer to get them to print.

The order arrived quickly and the packaging was intact. The cartridge was east to get out of the box and into the printer. I had a good print quality starting with the first page I printed.

Worked with no issues right out of the box. Solidly built and not manufactured from China.

[This review was collected as part of a promotion.] It started with taking the printer out of the box. A handle was created to pull the printer easily out of the box. I have never seen this before. This was really good. Installation went smooth, which included inserting the cartridges and the software installation. First prints are looking good, the printer is quiet and I am looking forward to more printing. So far it is already a better experience than the other printer brands I have experience with. Also looking forward to experience HP+ advantages. Never seen this with any other brands before.

The packaging was really nice the only problem I had was that one of the m.2 cover got stuck to the booklet.So I lost the thermal pad because it wasn’t good anymore. Besides that the other board is really nice and works perfectly definitely would recommend

It's my first time buying a RRS L-Plate since I have used cheaper China brands in the past for my other cameras. This plate feels luxurious in comparison with the cheaper brands. I highly recommend it. Otherwise, please note that BH staff pack like school children. If you are shipping overseas, you might incur bigger shipping costs. Please specify this when you make your next order. See the picture attached.

Needed a short cable to connect thermal printer to computer. Functions well.

One of my favorite ways to judge a boards stability is whether it sleeps and wakes properly. This one does. Other aspects: I've got reasonably fast ram timings on stock voltage. 6200 Mhz with 32,39,39,102. It did not like the XMP3 out of the box, which would have been the same timing but 6400 Mhz but its because I'm running 2x32 sticks and the manual says to expect no better than 6000. My cpu runs very cool... an i7 13700K cooled with a Corsair H170I Elite Capellix 420 mm AIO cooler in a Lian Li Lancool III White RGB. It holds at 75C for a full load cinebench. I did use a Thermal Right LGA1700-BCF BLACK contact frame for better heatsink seating. Arctic MX-6 Thermal paste. it idles in the ~30C range. Gaming it stays in the 40's most of the time with only incursion into the 50C range. the highest I've seen gaming is 58C which is great. the boards soundcard the Realtek 4080 is an improvement over the 1220 it replaced. they both sound great but the 4080 is fuller and louder. I love the intel 1226v NIC. My switch supports and I get the full speed. 4-NVME's is a great option. I'm only using 2 but will add more. This replaced a Ryzen 9 5950X. It is faster for almost everything, but for my primary box this is a great machine. I recommend the MAG-Z790-TOMAHAWK-WIFI

thermal pads, nice build quality, and xmp stable (6 hours) right out of box. (results may vary depending on mobo and cpu) I paired these with an apex encore and a 14900k. Plan to tune later but plug and play 8000 is crazy!!!