Cisco E1000 Wireless Router Software Download

This is a great little scanner! Download and install of the scanner software was super easy. My only complaint is that our router doesn't have a button to push to setup the wifi because we have a commercial grade router. So, I wasn't able to set it up on wifi. I was however able to setup using the USB cable. I wish there was an option to configure wifi when connected via usb. I LOVE that the scanner scans both sides of a document at the same time. This is a great document scanner. The only think that would make it better is if it could do higher resolution for pictures too, but it is just a document scanner and it preforms this task amazingly well. I'm very happy with this scanner! This is a review for the Epson WorkForce ES-300WR Wireless Document Scanner that I received free of charge to do a beta test and review.

very easy to use and with the software download.

I recently had my internet provider to increase my speed (from 150mbps download to 330mbps). It turned out that my old Wi-Fi card that I had on my PC couldn't quite handle the speed even though it was rated that it can. I bought this card out of curiosity just to see if it was the PC that was causing the bottleneck and not the card. Once I installed it, the download transfer rate just about doubled compared to the old card. In fact, the speed is about the same I'm getting if I had the network cable connected directly from the modem to the PC Ethernet port itself. Anyway, I would advise anyone to first check their wireless router or wireless modem/router to see what Wi-Fi standard it uses. If you still using an old modem/router, this card will only go as fast as that set up allows it to.

The typical home wireless router puts everything in one box - the router, software, and wireless access points. UniFi breaks it apart into plug and play modules that you can place anywhere independently. This gives way more configuration options which is all straight forward with the UniFi software. For those a little more knowledgeable on networking this is an awesome setup to have. Originally I plugged the UAP-AC-LITE into a EdgeRouterX but after power issues I upgraded to the Security Gateway which is a much better experience. Installed the UniFi software on my Macbook Air, it found and provisioned both, and I was up and running. Once it was configured I now only run the UniFi software when there's a need to check the system. This is enterprise grade with well considered management options and monitoring through an intuitive interface (four WiFi networks, customizable guest web page, deep packet inspection...) Great performance thus far, and with the UAP-AC-LITE using PoE I can have it on UPS while placing it anywhere there is an Ethernet port, like tucked behind the TV :-) Now looking to invest in a Cloud key (an independent little box to run the UniFi software) and a UniFi switch (to give more PoE). I'm hooked...

I am very impressed with the RT2600AC Wireless Dual-Band Gigabit Router. It was very easy to setup and update the firmware. It was so much easier than the troublesome TP-Link Archer AC1900 that I replaced. The Synology Router firmware does not require compression software. You just click find update and load it with the control software that is included. The dual bands are more than capable of handling many devices with ease. I have the Blast 150 Mbps package and my Xfinity speeds are now 230-240 Mbps. I am extremely pleased and highly recommend this router. I will buy Synology again. B&H is also fantastic.

I got this to replace all of our wireless needs. I disabled wireless on our router and use this AP as our only source of wifi. The software is so amazing. We get better range and speeds in our home. Going to get the Ubiquiti USG and switch later.

Very easy clean setup with this UAP. I wanted to relocate my wireless access point (wireless router) from it's poor location so I was able to cleanly install this on top of my entertainment center with only a single CAT5E cable. Works like a charm. SETUP The product was very simple to setup. I ended up at first just using the iOS app to set it up which allow for you to get it up and running quickly. I then later installed the controller software on my iMac (after deciding my raspberry pi wasn't a good idea). The software is much more robust in terms of what it can do. Here you can RF scan, and check your site out. The controller software isnt required to run all the time so this is a good option to see what it can do. Only certain features will require it to be running all the time. Overall I'm very happy and am planning on purchasing a Ubiquiti Edge ER-X router in the near future and possibly even a Unifi Cloud Key, although, for a residential unit, it's not really needed.

Transaction went perfect. Easy to download the software.

Easy to use. Download the software, plug in, and let it do its magic.

My old Cisco stopped and had to get a new one. Just bought a new Night Hawk router a few months ago. This new modem is really fast and pairs up very easily