Connect Two Routers Without Ethernet Cable

I like the wireless satellite. It will allow me to connect a window PC via Ethernet cable to the internet.

I used the cable to connect two wireless routers. Long run, about 80ft of a cable. It was easy to install and works with no problems. It's inexpensive and for permanent installation like mine works perfectly fine.

Not much to say about an ethernet cable, except that it works.

Used this for a elevator camera conversion. This allows you to use a single BNC coax cable to power and connect a Ethernet POE camera. You only need to supply 24vdc to the near end converter. It also extends the operational distance limitations. very nice

Purchased to connect a Wii to a cable router through an Ethernet cable to watch streaming Netflix. The setup was easy, just plugged-in the adapter, connected the cable, went into the Wii setup and told it to update, inserted the Netflix disk and I was done.

CONNECT TWO CABLES TOGETHER

Short Ethernet cable that works.

Ethernet cable wet dream.

A Ethernet cable that works! And it was low cost.

This TP-Link ER7206 router was purchased to replace an ancient D-Link DGL-4100 router that still worked but which no longer maintained full throughput and which didn't support IPv6. Both of these routers have built-in 4-port Ethernet switches. When it comes to Ethernet routers, my needs are quite simple and the ER7206 meets those needs perfectly. So far it seems to be performing flawlessly. The router is being fed by a cable modem (550 Mbps downstream and 22 Mbps upstream) and has a computer, color laser printer, smart TV, and Wi-Fi Access Point (AP) connected to it. The AP has a built-in 4-port switch to which a Blu-ray Disc player is connected. The router was directly connected to a computer for setup purposes and the process was straightforward. I did update the firmware, which is always a good idea since some fixes may be security related. If your needs are as simplistic as mine, then I highly recommend that you consider this product.