Cr2032 Battery Mitsubishi

I run through a bunch of CR2032 batteries every couple of months. I like these because battery life has been good, and I can buy them at a reasonable price through B&H.

The RAYOVAC CR2032 Lithium Battery (2-Pack) contained two, count-em two CR2032 cells. Absolutely amazing!!. These were purchased as spares, so I have not measured their voltage yet. Presumably, they will produce the rated 3 Volts and will last for 190 to 240 mAh. They are 20 mm in diameter, shiny and light weight and most likely contains some lithium & manganese dioxide so are technically a LiMn02 cells. FYI: They can explode if heated to more than 80 deg. C.

Good Price for the Mitsubishi 5x7 Paper.

I bought this case for a Mitsubishi CP-M1A photo printer. The case is a little oversized for the printer, but I added a little extra padding and it fit very well. The case construction is very strong and solid. Considering the weight (30 lbs) of my printer, the side handles really helped for carying the heavy load. The case comes with velcro backed pads that seem to provide a good level of protection. My only request would be for a shoulder strap, or at least loops that a shoulder strap could hook onto.

I bought this amp to replace a pre and power Mitsubishi amp that was over 40 years old. The old amp was great but the power amp finally died. This is working very well for an amp that cost about the same as the old one. It is driving 2 major speaker sets in different rooms and I really like the feature. I like the CD amp and pure direct and my B&O turntable sounds good too. Good amp for the money.

I wish Mitsubishi made a more durable replacement, but this is a direct replacement for the part that comes with the printer. The price seemed unusually high, but I needed one, so it had to be ordered. Good news when it arrived, and there are 4 replacement trays per box.

Easy to install and very small. Had to hook my linear turntable to an AUX port on a Mitsubishi receiver. This little preamp does a great job!

Good case, but not quite the right size for a Mitsubishi CP-K60DW-S Dye Sublimation Photo Printer. The case has a single divider, that only works in the shorter direction. The CP-K60DW-S only fits in the long direction, rendering the divider useless. The case should come with a longer divider, or B&H should not recommend this case for the CP-K60DW-S

Particularly for the price point, this paper is as good as any other luster paper. Theory has it that almost all luster papers come from the same Mitsubishi plant and are just rebranded, sometimes with a much higher price point.

These are MCC03RG20 discs. High quality media made by Mitsubishi Chemicals and branded for Verbatim. Nothing more to say.