Cr2032 Battery With Wire Leads Cmos

I run through a bunch of CR2032 batteries every couple of months. I like these because battery life has been good, and I can buy them at a reasonable price through B&H.

The RAYOVAC CR2032 Lithium Battery (2-Pack) contained two, count-em two CR2032 cells. Absolutely amazing!!. These were purchased as spares, so I have not measured their voltage yet. Presumably, they will produce the rated 3 Volts and will last for 190 to 240 mAh. They are 20 mm in diameter, shiny and light weight and most likely contains some lithium & manganese dioxide so are technically a LiMn02 cells. FYI: They can explode if heated to more than 80 deg. C.

bought this for my Canon CMOS HD: an older camera. Much cheaper than a Canon battery and it works great.

Installed fine in my Alienware Aurora R12. Did a CMOS reset and battery reset. Computer rebooted several times and finally booted to Windows. So far, so good. I now have this RAM installed alongside the OEM ram for 48gb.

Wire connectors were difficult to remove from old battery Short wire lengths made connection to new battery challenging

Long wire, comes with the battery and wind screen and clip. Happy with it.

I bought this to upgrade the CMOS and still accommodate my lenses. Good deal!!!

battery is grate and the charger is easy to use but there was no wire for charging this battery had to go and by one from the ATT. STORE

I've successfully used the larger version twice. It's cleaned the spots off the CMOS without damage to the chip.

Perfect to use with HD CMOS video cameras like EX1, EX3... Sometime you have unwanted reddish blacks because of infrared contamination in the picture. That's not a camera default : that let you the maximum red light width entering in the CMOS, but that can create unwanted effects, specially in blacks. Using this T1 filter will remove this bad effect and produce (after good white balancing, preset or mesured) a perfect picture. And not too much flare effects with incident light. A must have for your gear...