Dead Weight For Whirlpool Front Load Washer

This is a bargain for the weight load.

If you find the need for an adapter this one is very strong and has a soft washer to protect against scratches. You first will noticed that the adapter actually has some weight to it.

Best for its size, weight, load, stiffness.

I used to have a load of loose rechargeable flash batteries in my bag. This simple little item has now sorted all that out. My batteries are now all in order and now I know which are still fresh and which are dead. Fresh ones right side up, dead ones upside down. Love it! You will not regret purchasing this and at this price it's a no brainer.

It's a wheel. It rolls. It holds a lot of weight. Comes with a set of replacement washer and pin, but no end cap. As is with the case with all other RocknRoller products, the box basically all came apart during shipping, but I am glad that B&H ships this item with their own box around it.

Someone please tell me any other film washer better than this.

Using in church venue ceiling height 12ft. Running mono system with sub, Speaker is mounted to ceiling 51ft from back wall centered on 60 ft room width. Previous speaker a Renkhas Heinz too loud below and directly in front of speaker, dead spots in back corners of room also high end muffled dropped off significantly to the side. Did a lot of research looking at polar patterns of different speakers and the Toa fit the bill what clinched it was the ability to adjust the dispersion angle of each speaker in the array. Initally was going to mount it horizontal but the dispersion wasn't good so mounted it vertically and by adjusting the speakers the dispersion is great, not too loud in front and underneath, no dead spots in corners, highs are crisp full 180 degrees around room. Also purchased the adjustable ceiling mount.

Without this all the weight will be in the front but this makes it equals and it fits better

Load everything up and move it from one location to the next. All my equipment fits perfectly. Collapses down to fit in the front seat area of my car, with the wheels on the floor. Don't need a truck just yet.

I haven't actually used this yet, but I did load it, weigh it, and pretend to put it in an overhead for practice. Seems perfect for my gear. I travel with a DLSR, mirrorless and 4 lenses. There is room for that and a change of clothes if a bag gets delayed. The front compartment easily holds my 15 laptop. The laptop compartment sort of locks by attaching the loop on the zipper to the integrated lock for the case (watch the video). The case rolls easily. I agree with the reviewer who said it would be nice if the bottom of the case was flat, but with my gear that is not a problem. The recommended accessory GRID-IT organizer of 10X12 does not fit the interior front pocket and looks like it has been removed as a suggestion. All-in-all this looks like it will be a great bag. It will be my carry-on but seems sturdy enough to gate check on smaller planes.