Dell Precision 5510 Ethernet Adapter Driver

Bought this product to hook-up a 2nd large monitor to my Dell Precision 5510 laptop (USB-3.0 C laptop output to DVI input of the monitor cable). Adapter worked great, 2nd large monitor is up and running, a big productivity improvement. Saved a bunch of money too since I did not need to buy a more expensive docking port to perform the same function.

This adapter works well with Linux, but will require the user to compile the open source driver and install it. Careful instructions are on the web. I use it on a workstation normally attached to ethernet, but occasionally in need of wireless access. Quick speed test on a strong signal was about 250Mbps (650Mbps on ethernet).

Successfully recognized in Dell Precision laptop (2 lanes)

No issues installing this into a Dell Precision workstation laptop.

Not much to say, it's a USB to Ethernet adapter. Works exactly like you would want it to.

Works very well in my old Windows 7 Ultimate, Dell Precision T1650...Nice speed increase for post processing photos in Photoshop and Lightroom Classic. Great service from the folks at B&H, as always.

[This review was collected as part of a promotion.] The Belkin USB-C to Ethernet + Charging adapter is amazing tool to have with you when you need an ethernet connection. The USB-C to Ethernet + Charging adapter charges your connected device while also providing an ethernet connection, so no need for multiple connectors. I have been using this on my Android phone and my laptop, both devices have a USB-C port and my Belkin adapter worked great on both devices. It provided an adequate charge and a stable internet connection without any issues. The adapter was immediately recognized by both devices and there was no need to install any software to make the adapter work. The adapter is also small and portable enough to carry with you anywhere you go. I would highly recommend this adapter to anyone looking for an ethernet + charging adapter.

Since this device is so new, the device driver for Wi-Fi and Ethernet is not in the installation software for the operating system. You must connect an external USB Wi-Fi so that it can download the device driver from the internet. Other than this hiccup, everything works fine. I bought three.

The assembly was easy, and the driver installation was easy, and the ethernet cable connection was easy, and paper roll loading was easy, and then the plotting worked well. Only glitch was the driver software creating two printers, and no documentation on which was which (one was ethernet and one was USB).

Used two of these on a Dell 7010 i5-3470 with the built-in Intel 2500 graphics, together with the built-in VGA port, to run THREE VGA monitors simultaneously under Windows 10 . Need to disable the Dell driver and then get the driver from Intel as Dell disable 3-screen functionality. I was a little sceptical at first whether these would do the job, as many 'active' adapters are a lot more expensive. An added bonis is that these don't need a separate USB port for power.