Dewalt 3400 Psi Pressure Washer Spark Plug Size

If you haven't noticed in the pictures, there are two foam trays. So the case is almost twice the height of other cases. All items the cutouts are designed for fit snugly. The cutout for the Spark is deep enough so that the props are below the top of the foam. This means the egg crate foam in the lid will not put undue pressure on the props when the case is closed. The full fly more package will easily fit plus an OTG cable and other accessories. There is a rubber gasket around the lid and a raised ridge around the top of the base. These two come into contact when closed to create a watertight seal. There is also a pressure equalization valve as well. When you open the case there is a detent to keep the lid open. The only hit I have is the foam bottom for the top tray may split in high use cases. The bottom foam is only about 4-5mm thick. Should this happen or to prevent from happening you could apply some gaffer tape under the controller and Spark to reinforce the foam. So far there are no indications this mod is needed In the three months I have been using the case I have had no issues with it. It’s nice to be able to fit the Spark/Remote Controller/Charger and Hub/Prop Guards/Accessories in just one case you can quickly grab and go. All in all I would say this is one the best hard cases for the Spark when basing it on price and value.

A perfect fit for my spare DeWalt 20V, 5Ah battery.

I bought for my husband and he said it hits alot harder and clearer than his dewalt boombox.

I use it for movies and playstation 5. Both are amazing The white version goes well with my ps

We use this product on industrial 110V pressure washers. All the new units have the 20 amp plug on them and we rarely have access to those outlets. We used to go to an electrical supply and buy components and make our own pigtail converter. This set up is MUCH easier and cheaper.

Someone please tell me any other film washer better than this.

Works very will and makes the Spark much easer to operate

The only thing I notice: the size is not the same, someone are a little bit more large and you need to put a little pressure to fit in place. But that the only thing.

I checked PSI website for correct swab to clean my Nikon D500. They recommended the Type 3 - 24mm you use for full frame . Don't use it. The Type 3 - 17mm swab is the best one to use for a crop sensor. I had to use 3 swabs to get the sensor really clean. There also a magnifier with a light built in you can use to view the sensor. Definitely get it . So worth the $15

This is the best blower around when comparing air pressure and size. It blasts dust with one squeeze. It fits nicely in my bag and doesn't take up too much room. Saves from having to use the cloth too much.