Diy Ps4 Controller Phone Mount

This is the best gimbal around for the price. It works great with a PS4 controller for wireless control.

Needed to go from headphones with separate mic and speaker inputs to PS4 controller. This adapter looks sturdy and works so far.

I don't need to cut up anything to mount new DIY straps

If you have more than one phone you need these to use along with the Magnus Mount.

the different ways to mount the phone is a plus.

I use them to mount DIY ligth on my c-stand (with superclamps). Love the fact that i can use 8 screws to make everything secure.

I have an Pixel 7 Pro and needed a Car Mount that didn't fall off my dash. The PD Car Mount with the charger work better then great. Just put the phone near enough and it just mounted. I was worried the mount would detached it self from my dash board (like 2 other brands), but now after 2 months I'm sold. Also I used the adhesive phone case mount because the PD Phone case was backorder and It is working great, most likely will just cancel the PD Phone Case order.

I used this per photography forum recommendations to use as part of a DIY project to mount the Speedotron Beauty Dish to my Genesis strobe lights. This adapter is made of higher quality metal that doesn't bend when pressure is applied, thus drilling the 4 mounting holes was a breeze. I also bought this adapter to use to secure the diffuser sock on my Photek Softlighter II to my strobes, since the stock Genesis reflector is too big, and the Elinchrom Wide Angle Reflector costs $50. Great alternative!

I use this adapter to mount a shotgun mic shock mount (standard 1/3 microphone thread mount) onto a 5/8 mount, which is a sort of DIY boom pole that I have (It does the job as good as any). What can I say, it works exactly like it should. When it's screwed into the shock mount you can't even see it. It looks clean and professional. You could also use this to mount on a tripod or other standard 1/4 mounting device. It's reversible too, so it's pretty versatile; allowing both male and female outputs for both. Sometimes you need to use a coin or flat object to unscrew it because it gets kind of stuck, but I suppose that's a whole lot better than having to worry about it falling out.

Such a great lighting tool, really love the quality of the light and use it for all my fashion ecomm work. Provides a crisp and even light with soft fall off. It's huge at 75 so not for everyone or every situation. With it's size it does need a lot of power, I'm looking to start using a Profoto twin tube with this as it'll give me the power I need and help cut my recycle times (I usually shoot at f/18-22). The only down side, but easily resolved, is the horribly designed stand mount. A lighting tool of this size requires a much more stout mount. The one included is toy like with all it's plastic parts and will not last. I strongly urge everyone to replace it with a hollywood grip head immediately! I've attached images of the upgrade, take 2 min to swap them out. I recently replaced a broken rod, Elinchrom/MAC Group was super helpful and sent the rod for a DIY fix. I could have sent it in for repair but opted for the DIY at a fraction of the cost ($22 w/shipping). The replacement took about 20-30min and was easy just requiring a phillips head screw driver and steady hand (several small pieces inside).