Do Bluetooth Ceiling Mounted Speakers Need Power

A must-have for use with ceiling mounted lights!

DOES EXACTLY WHAT I NEED IT TO DO.

Speakers mounted outdoors, ceiling-mounted under an eave, about 25 feet apart. Very pleased with the sound, which is rich with bass, crisp highs, and pleasantly filling the space. Not sure why many reviewers detest the sound quality — they must be high-level audiophiles with expectations well beyond mine, or suffering from hearing loss in some bands of the frequency spectrum.

I use this amp to control 2 sonos speakers that are mounted in my kitchen ceiling. I was able to fit this amp in one of my kitchen cabinets with its small design and run the wires directly to it. Now its easier than ever for me to stream music!

I mounted these in the ceiling facing down in an outdoor cabana that's 36' x 24'. The speakers are powered by a Denon Heos amp and they crank. The sound is amazing...you will not be disappointed!

I bought 6 of these amps to individually power ceiling mounted background music speakers--Polk Audio RC6s in my case--in my office (to enable individual volume adjustment of each speaker). Music is provided by a Sirius satellite radio receiver. The system works well and after hours, I can crank up the speaker in my office if I am so inclined. The amps each have RCA inputs and outputs so it was simple to daily chain them together to create an integrated system. Satellite receiver into one, output of that one to the input of the next and so on and so forth. Took minutes to hook up; after 6 months, I have no complaints.

I bought this AP and a related router to replace an aging consumer grade wireless router which I had. Setting up this AP was a breeze and I'd recommend this to anyone wishing to implement or extend a wireless network in their home or small office. The thing to keep in mind is that this is intended to be mounted on a wall or preferably a ceiling. The router only requires a network cable and you use the included power injector to power the unit. This AP will require some other device to route the traffic from your web provider. Configuration is easy with the Unify controller software installed on your pc. Wait for the AP to power on, load the software on your pc (on the same wired network), and let it look for and provision the AP. You can configure a single combined SSID for 2.4 and 5ghz or separate and configure a guest network if so desired. Once configured, the AP has been running without issue solidly for a few weeks now. I have my PoE injector in my office and plugged into my UPS along with my modem, router, and switch. If the power goes out, all of the wireless and internet access will stay up. Be sure to test all your ethernet cables prior to installing everything. I had multiple issues with the cables I was going to use initially. One cable would only allow a max 100 connection, the other would allow gigabit, but the rj45 connector was able to pull back just enough while connected to cause an intermittent connection. Swapping to higher quality cables solved these issues. I have a 3800 sq ft house in an L shape. This AP is on the second floor in the center of the house. This works well for coverage everywhere and I've even seen coverage in areas where I had little to none previously. I've got it mounted in the ceiling of a hallway next to a smoke detector. It doesn't look too out of place except for the blue glow (which can be turned off). I'd recommend this to anyone that has basic networking and computer knowledge looking for a solid access point.

Need more power, This will do the job.

The perfect solution for my old ceiling speakers...

I'm using this to power an in-house music system. Ten ceiling speakers. I can't believe a 50-dollar amp works so well. Honestly amazed.