Egg Shaped Musical Instrument With Finger Holes

These headphones are great for tracking drums or any musical instrument! Love them!

I used to work in musical instrument & pro audio retail and I hate to pay retail for cables, but I also realize the value of having good cables where data and audio transfer are critical. I bought these cables for all of my camera tethering and for data communication with one of my synthesizers to communicate with my computers. Im very pleased with the construction and performance & I also like the bright orange so these cables stand out from my other data cables.

A well made musical instrument cable for light duty use at a very reasonable price point. Cable is very supple and well made from both a mechanical and electrical perspective. Wire and braid are soldered to the connector, not crimped, I like that. Shielding from electrical noise and interference (radiated susceptibility) seems adequate for my use. Cable microphonics do not seem to be a problem with this musical instrument cable.

This is a great case. I've had good experiences with SKB in the past for musical instrument cases, and this is no different. I have 2 Sony a7iii camera bodies and an assortment of lenses in here, and it all fits nicely. The lid organizer is a nice addition too.

I have been using the 15-key Stream Deck which works great, but I'm now learning a new musical instrument via online video tutorials and I needed a way to do mouse clicks without removing my hands from the instrument. The Elgato foot pedal works perfectly for this using the SuperMacro plug-in in the Stream Deck software.

I do various recordings as far as voice, musical instrument instruction videos, music tracks for various clients. For a while, I've used the Blue Yeti and always knew I needed a better mic but didn't know what to get. Plugins in post can take you very far but, overall I knew I needed better hardware. This mic was rated very high for it's quality to cost ratio. I'm a saxophonist and I needed a large diaphragm condenser for what I wanted to do and this was at the top of the pile of my choices. It was a major quality increase. I paired it with a Focusrite 2i2. Very round and thick sounding. I've watched videos and comparisons It's response curve is relatively flat compared to the NT1-A. Also it's extremely quiet. I won't need another mic for quite awhile.

I needed a power supply for a musical-instrument device that I bought used. This power supply met all the technical requirements (and its price was much lower than elsewhere), except that its plug had an incorrect center-pin diameter (I wish the listings for such devices included that spec; they seldom do). Luckily I had a power supply with the right plug that I don't need; I spliced that power supply's cable onto this one since I have the necessary tools and skills. It's now doing the job!

It was easy to install. I could not fit my older sound bar without adapting with an “L” shaped bracket since there was no holes in back of sound bar.

But does NOT fit the Sony RX100 VI with finger grip. 1/4 inch mount holes do not match up.

These gloves are very warm. I had to stretch out one of the holes after i flipped the finger back to get my thumb to fit properly but otherwise a great set of gloves.