Electric Hot Water Pressure Washer 3000 Psi

The Paterson print washer is a real time-saver. Just a gentle flow of water is all that is needed to activate the auto-agitation which operates without fail.

I've had a couple of these over the years and they always perform perfectly. We are on a well for water so conservation is critical and this print washer minimizes consumption while flushing out chemicals perfectly

I'm usually satisfied with Paterson products and this washer is no exception. It's made of durable plastic and the water hoses are thick and don't feel cheap. It washes paper well even with low water pressure. Worth the money.

I purchased this stock for my Canon TX-3000 wide-format printer in order to offer my clients an option for water-resistant banners, poster, etc. The stock is on the thinner side so I printed out some posters and installed grommets on the corners to check out the tear-resistance. It didn't take much to tear the stock when pulling on the grommets. I doubt it would be suitable for hanging outdoors in an area that would experience high winds for an extended period of time. I have a feeling the addition of some tear-proof tape being applied to the backside prior to inserting the grommets may help with tear-resistance. The TX-3000 uses inks that are water-resistant so to check out what would happen if rain, snow hit the stock, I poured some water over the poster and the inks never smeared or ran. I think this will be a nice addition to my stock offerings for my clients.

I use it for movies and playstation 5. Both are amazing The white version goes well with my ps

Someone please tell me any other film washer better than this.

This processor runs hot. Make sure to use a cooler with lots of ventilation or go with water cooled.

I checked PSI website for correct swab to clean my Nikon D500. They recommended the Type 3 - 24mm you use for full frame . Don't use it. The Type 3 - 17mm swab is the best one to use for a crop sensor. I had to use 3 swabs to get the sensor really clean. There also a magnifier with a light built in you can use to view the sensor. Definitely get it . So worth the $15

Wow. On my small sailboat I used it to run my hot water kettle, shop vac to suck up water, and portable refrigerator. Planning to add a microwave. Charged well with solar panel. This will make extended sailing/anchoring so much more comfortable. This is one impressive device.

Powers hot water tank, injector pit pump, and fridge effortlessy. Not all at the same time. Individually.