Factory Radio Amp Adapter

I literally take your speaker wherever I go. I even prefer to play it on the car opposed to the factory radio.

I've always loved using these in radio, so when I had to build a microphone distribution amp, this was my first and only choice.

In our radio station we use this amp to distribute monitor audio to studio monitors, CD recorders, MP3 recorders and phone system. The adjustable levels on each output support broadcast and consumer equipment looking for -10 or +4 levels. This DA is built like a tank. As our first piece of Rolls gear at a very nice cost, we will be considering their other gear in the future.

This thing is amazing! We do a travel radio and TV show and we are always trying to keep our gear kit as small as possible. This headphone amp is the answer. It is made of metal, not plastic, so it is much more sturdy than other units. The output power and fidelity are excellent. I can't find anything to complain about. Thank you Polsen!

I use mine for my ham radio equipment. It lacks just a little space so I keep the 4 AMP battery in the back back. At times when doing (SAR) I have to remove my pack and lower it but it doesn't always go down the way it should. The back get banged against the rocks but I know my expensive AM RADIO gear is safe. I also purchased the next size smaller and now going to buy the orange Pelican as a gift. I have nothing bad to say about the pelican boxes. BOB LECH AF2Q

We paired this with Pyle Pro PDWR40B 5.25 Indoor-Outdoor Waterproof Speakers for a standalone ice cream shop. The amp is mounted inside and fed by a standard radio. Also have installed a simple microphone so that the owner can announce orders when they are ready. The microphone uses an XLR to 1/4 adapter and has an OFF/ON switch. Normally the radio station is fed to the speakers and when an order is ready, the owner slides the switch on the MIC to ON, and the radio audio decreases. This is a great feature for this amp and works great for the restaurant. I liked this so much that we bought a few more Pyle amps (Pro PCA3) for in-studio use. Rugged design. Straight-forward setup. Will buy again!

This is a screw-on adapter to replace the factory supplied thread protector on the f2.0 lens. You must remove the thread protector before attaching the adapter ring. To do this, wear a Playtex rubber glove to unthread the original ring counter clock wise, you will never get it off using bare fingers. Just tread on the adapter and then the glass filter of your choice as long as it is 49 mm diameter

awesome little adapter, works great. Awesome to not have to keep batteries charged or use the giant factory charging brick

Factory made ink is always going to be the best... You might be able to get ink cheaper, but... it's cheaper!!! I'm tired of cheaper printing and now just use factory ink...

it works just like the factory ones!