Fender Steel Lap Guitar

Great for sustaining notes on my lap steel guitar.

This is one of those must haves that will get very little use, but in a pinch....plus I can use it for jams on my lap steel.

The cord on my Fender Guitar Amp is only about 4 feet long so I am limited as to where I can place it. This 10 foot heavy duty cord lets me place my amp almost anywhere now. It also handles the voltage and amperage which my amp requires.

I vacillated over which mic I should buy to pair up with my acoustic guitar and my Fender Acoustic Junior amp. This turned out to be ideal.

I purchased a second BR-10 to complete a PA system I use with a Fender guitar/Yamaha modeling amp combo. I get the sound I like and then let it rip. Clean, powerful and impressively responsive across the entire frequency range. Way more than enough for 1500 sq ft of audience (~200 people). Can switch to pure PA use without problems and nobody is going to gripe about this rig. Wish I had this setup when I started doing gigs.

Bought two of these. One for at home and one for my uncles' house where he is teaching me steel guitar.

Both my wife and I have one of these. Exactly as described. Works perfectly. I use it on nylon string, steel string and lap steel guitars.

On Stage I play guitar standing and a lap guitar while sitting. I mount my personal monitor on this stand. Now I can quickly adjust the height for monitor placement quickly for sitting or standing.

I was using a smaller version of this and could never keep my music on it. I fasten this to a mic stand on the side of my steel guitar, and until something better comes along, this is it!

This compressor is incredible for pedal steel guitar. Channel 1 goes to volume pedal, 2 and 3 stereo at end of chain for more comp/limiting of peaks and noise gate since I have single coil pickups. Full control, perfect!