Fit Bit Tracker Solders

It tracks! It's a bit less likely to become occluded on the waist too. Pairs with the Tundra Tracker SW7 dongle that I already had. Should be compatible with the SW3/4/5 too.

This is a very nice, easy to setup and use tracker, The fit and finish are fine and the results (prior to the 2017 eclipse) have been astounding. If your doing astrophotography, this is a great and cost efficient way to work with a DSLR and telephoto lens.

I saw this recommended to fit between my Move Shoot Move star tracker and the ballhead under my camera body. It solves the problem of the ballhead directly on the MSM coming loose as it rotates throughout the evening. I use the set screws on the undreside of the QS-50 to get a tighter connection on the MSM. So far I have been using it to do longer sub frames and for up to two hours without any problems.

I purchased this to attach from my Nikon to a star tracker. This size was too big to fit into the star tracker. I am hanging on to it because it will fit something else. I ordered the Vello 2.5 mm remote shutter release cable and believe that will work the tracker. The cable releases from Vello seem to be dependable.

Great notebook. I use this as my gardening tracker so it holds up well.

just need to get used to how to fit in in the charger. a bit tricky.

Great little gift item to come with the star tracker

Fit a bit tight, but works as designed.

A bit pricey for being just a cap but it does fit perfectly.

Polar alignment was simple and tracker worked past 2 and half minutes when shooting.