Flashing Red Light On Treadmill Circuit Board

Bright white light is very bright. Red/red-flashing light is cool -- not sure if I'll ever use it. Good fit and balance (with batteries in back). Lightweight and comfortable. Looks suitably geeky. Very happy with my purchase.

This is a very nice headlamp, without two levels of white light, a red light and a flashing red light.  Having the battery pack on the back makes it much easier to balance and the straps are adjustable over a wide range.

My APC UPS sounded off every few hours with beeps and a flashing red light to let me know it was time to replace the battery. I ordered online and the battery arrived sooner than expected. I installed it and it's been working fine since. The part I especially like, I didn't have to shut everything off to install.

Night and day difference between this and an all circuit board pre... nice and mellow even before it hits the DAW.

but it is unsettling to have the upstream light flashing

I decided to retire my first warthog throttle after having to replace the main circuit board and noticing how much wear the internals have suffered over the years of daily use. The original still operates well, but it is getting pretty loose in its advance age. These units are built like a bag of hammers, robust and tough. I do really appreciate the upgrade to the slew control over the old design.

This is a great tripod! I've already used it for both a product shoot (printed circuit board) and test equipment screens at work, and took photos of the family at Thanksgiving. The latches are stiff, but should insure a good sturdy support for my camera. The horizontal arm worked great for Macro work. I also have their monopod, a great 'pod for my walks.

I bought this for providing audio during film shoots. The design seems really tough, all metal construction. Looks like something that could be dropped on the floor a few times and still keep working. Good clean amps, but not a huge amount of gain. A few very minor critiques: uses AAA batteries ( I would have preferred AA as everything else on set uses AA), case is easy to open with ballpoint pin but can be put on backwards and then does not quite lock when closed (either make it impossible to put on backwards or it should lock when on backwards), two internal circuit board switches (mono/stereo and low/high power mode) the low/high power switch is hidden and not easily visible. It is a little awkward to have to access circuit board switches to adjust these settings. Overall very happy with the product.

This is a solid piece of equipment. It is slightly difficult to install the clip without damaging the circuit board inside, but definitely not impossible.

Brother Toner works well in Brother printers; however, OTC generic brands at a much reduced price also work well. That said, there is one application that one requires original Brother toner. That is printing on blue transfer sheets for making printed circuit board etching masks. In this process, one inserts a sheet of blue transfer paper in the Brother printer, and prints the line and land pattern 1:1 scale, on the blue transfer, and then irons the transfer on copper printed circuit board at 300 F. This transfer process does NOT work with generic toner because characteristics of toner fusion and density differ from Brother. Transferred generic media is thin (not dense) and adheres poorly, whereas Brother toner works wonderfully.