Flat Cabinet Door White Bookshelf

This dry cabinet works perfectly well. I like the Red Mahogany look a lot. The only regret I have is that I didn't get a bigger version because I already ran out of room. The shelves work great and being able to change where the shelves are located is huge. The dry cabinet starts removing moisture as soon as you close the door. There are only two cons: 1. If you lock the door, you can still pull on it and it opens slights before the lock blocks it. I wish the lock blocked you from opening it at all. 2. The humidity increases really fast if you have the door open for longer than 30 seconds. This is probably not something a dry cabinet can prevent though and is just natural in high humidity areas.

Cabinet was easy to set up. It's sturdy and you can feel how well the front door seal holds. I store mostly filament, and there's a drastically lower amount of moisture creeping into my test spool over the last month.

This dry cabinet is particularly well built. It has a nice glass door with a lock. When it came the cables came loose from the back of the LED controller and I had to get a flashlight and plug it back in. But everything works as it should. It is a particularly nice cabinet for the money. I would like to see them put wire retainers in place to hold the wiring during shipment and to keep it out of the way of your equipment. The rest looks great.

My Hegel H590 was getting a bit hot inside a BDI cabinet with door in front and open in back. Putting this on top of the amplifier keeps it cool. Fans only come on when temperature calls for it. Fairly quiet--not perfect-- but behind a closed door with sound playing you do not hear it.

I shoot a lot of products, mainly cabinet and door hardware with this lens. I also do art reproduction which this lens excels at for a nice distortion-free image. What I like about the 70mm focal length is that I can get a good dynamic image on a a7RIII, but then a tighter 105mm look on my a6500. So very versatile. The weather seal is nice too! I should say that I rented this lens and the Sony 90mm and feel that this lens performs just as well at a lot less cost.

I have used this a few times to mount a flash low. This plate has many uses. I have an old cabinet door that I mount the plate to and I can slide that on the floor easily. I sandbag the door to keep everything steady.

I recently purchased this unit from B&H after having some older 35 mm equipment damaged by mold / fungus on the glass lens elements. The Sirui unit is pretty well-made. Caveat: I did have the first unit arrive with serious damage as a result of poor manufacturer packaging, but B&H handled the replacement within 24 hours. Several people have asked about how the water drains from the unit. Well, it is not like an air conditioner or de-humidifier; the unit is only removing a fraction of an ounce of water from the air volume inside the humidity control cabinet to control the RH. It only has to perform this action once after you open and close the door, and then periodically if any moist air should enter the case. Also, it is not a traditional de-humidifier, but rather some sort of light activated catalytic moisture absorbing reaction (see Sirui website for details). So far the unit works as intended. The settings are holding the RH within the stated range of +/- 5%, and once you determine the offset, it holds very steady at the set point. The cabinet has a nice handle and sturdy lock, which is not bugler proof, but is a nice security feature to at least keep the door closed and family out. The energy consumption should be about $0.25 a month based upon the specs I read. I keep (2) large format lenses, (2) medium format bodies, (2) rangefinder bodies, about (12) various lenses, plus meters and speed lights in the HC-110. A smaller collection could easily fit into one of the smaller Sirui cabinets, IMHO, B&H should be selling a lot more of these units. It is a small percentage of the cost of all of my gear, and I feel better about knowing it is stored properly when not in use.

When I was shopping for a dry cabinet, I looked at a few options, and decided to get this one. So far, its been good but not perfect. It keeps dry even if you unplug it a few hours. It feels solid, and its made of 1 mm thick powder-coated steel including the shelf. The hinges and shelf clips are 2 mm thick powder-coated steel. It makes a solid sound if you knock on it, and the door sounds like opening and closing a nice refrigerator. Out of the box, the handle comes on the inside of the door, so you have to take it off and mount it on the outside. You get two pieces of precisely cut open cell foam. One is sized for the bottom, and one is sized for the shelf. It runs off a small power brick with an L-shaped barrel connector that plugs into the back of the cabinet and puts out 5 volts 2.0 A, so its basically like a small iPad charger. The dehumidifying unit is on the upper center, and there is a cable neatly routed above the shelf rails to the control board in the front of the cabinet. Theres a single light bar on the front right that illuminates the interior. Its daylight white and a good brightness. It plugs into the control panel and you can turn it on or off from there. The screen on the control panel is easy to read with large letters, and you can adjust the display brightness between bright and dim. The controls arent the most intuitive, but once you read the instructions, its easy to use. The only complaints I have about this cabinet have to do with the lock which I dont use and the shelf placement. You cannot place the shelf in the center of the cabinet if you want to use the lock. In the lower position, the door will not close because the lock will hit the shelf. In the other position, the shelf prevents the lock from turning. The keys are really cheaply made and are probably stamped instead of cut, and they are quite roughly made with cheap-feeling plastic heads. In some upper positions, the dehumidifying unit also interferes with the shelf.

delivery as B&H covenant, careful packaging, adjustable cabinets work normally, but the one drawback is that even without opening the cabinet door, the humidity is still increased then the dehumidifier operates humidity As it was chosen, and kept moving like that, it could be because the rubber band on the cabinet door leaked, the cabinet generally works very well. Thanks B&H

The build quality is great and includes the foam liners for the trays. I wasn't expecting the foam to be anything worthwhile but it is in fact very good! Even includes one foam tray liner that has curved cut outs to hold your long lenses from rolling side to side. Fits all of my gear plus a little room for a couple of backup drives. Great to keep your gear dry and easy to get to when it's time to load up and go shoot. Pull out drawers are a nice touch on this cabinet as well but you have to have the door all the way open or you'll catch the rubber gasket with the edge of the drawer. This could easily be remedied by having the rubber gasket on the cabinet itself instead of the door but that's a minor design issue in my book.