Floor Desk With Drawers

The rip tie was perfect for organizing all of the loose cables that i had in my desk drawers.

Perfect fit for an AutoDesk standing desk. I mounted two side by side an they look like original equipment. These are not as deep as other drawers but then again those other drawers could not be mounted properly on a “Standing Desk.” Solid build and packaged well. Tidy's up my desk nicely.

Great card storage device! I was always searching through desk drawers and camera bags for lost cards. But no more!

Fits right on the end of the desk so I can get the headphones out of the way when not in use and not risk the cat swatting them off onto the floor.

great if you want a printer or the like not near your desk you can run this wire along the wall or floor

No more cord resting on the floor, and no more accidentally knocking the cans off the desk.

Easy assembly! Fits everything I need on it, without taking a lot of floor space! Really like being able move the desk as needed. A bit annoying having to adjust the height of the desk though.

This stand has been helpful in keeping my desk organize and keeping my headphones in good condition without it being all over the floor from someone stepping on it

Beautiful fit and finish as all Triad-Orbit products. Works alone as low stand for camera/light/mic. Mounts from above or below via attachment holes. Bottom includes thin rubber layer to provide isolation from desk, table, floor, wall, ceiling or whatever it is attached. I plan to buy more. Very adaptable attachment. I have a beautiful piece of tropical hardwood that I plan to attach to the bottom to provide more stability for my desk mic stand, and attached a Triad-Orbit IO-A1 Extendable Boom Arm, it fits perfectly on my desk. It looks great! I record Kirtan music where the musicians sit on the floor and it has proven very useful in this application. I have used it with a Wildtronics Pro Mini Parabolic Mic to make bird and ambiance field recordings in Costa Rica. It travels well.

I started looking at clamp on stands that would keep my cans off of the floor and from cluttering up the desk, but then I came across this stand on the B&H site. I was skeptical as to whether it would be sturdy enough and well balanced enough to hold my rather heavy AT BPHS1 headset. Surprisingly it's easily capable of holding two pairs of headphones, and I love the fact that it's so portable. What a great design!