Front Load Washer Loud

Someone please tell me any other film washer better than this.

Totally love this thing. Destroys everything I throw at it with resources to spare. Grab some headphones cause this thing can get loud under a load of graphically complex gaming. It is to be expected though. Totally worth every penny!

I use this for interviews in loud and quiet places. The mic really does a great job of picking up what's in front and not the surrounding as it's supposed to. Light weight and a great price.

Using in church venue ceiling height 12ft. Running mono system with sub, Speaker is mounted to ceiling 51ft from back wall centered on 60 ft room width. Previous speaker a Renkhas Heinz too loud below and directly in front of speaker, dead spots in back corners of room also high end muffled dropped off significantly to the side. Did a lot of research looking at polar patterns of different speakers and the Toa fit the bill what clinched it was the ability to adjust the dispersion angle of each speaker in the array. Initally was going to mount it horizontal but the dispersion wasn't good so mounted it vertically and by adjusting the speakers the dispersion is great, not too loud in front and underneath, no dead spots in corners, highs are crisp full 180 degrees around room. Also purchased the adjustable ceiling mount.

Has a semi-loud fan in the front. Does typical intercom stuff and has the rock solid performance you'd expect from RTS including the ability to do 2 channels of clearcom.

I have this mike and I love it. I can be right in front of an Island concert loud speakers and get quality sounds finally

Worked perfectly right out if the box on my new Mac Pro. Loud when backing up, but silent when not. Light on front is to darn bright! I put a sticker on it. The switch is on the back! Really??? Why? Annoying!!! Overall I'm satisfied and would buy it again. It is very fast! Seems instant on Thunderbolt with Mac Pro.

Load everything up and move it from one location to the next. All my equipment fits perfectly. Collapses down to fit in the front seat area of my car, with the wheels on the floor. Don't need a truck just yet.

I haven't actually used this yet, but I did load it, weigh it, and pretend to put it in an overhead for practice. Seems perfect for my gear. I travel with a DLSR, mirrorless and 4 lenses. There is room for that and a change of clothes if a bag gets delayed. The front compartment easily holds my 15 laptop. The laptop compartment sort of locks by attaching the loop on the zipper to the integrated lock for the case (watch the video). The case rolls easily. I agree with the reviewer who said it would be nice if the bottom of the case was flat, but with my gear that is not a problem. The recommended accessory GRID-IT organizer of 10X12 does not fit the interior front pocket and looks like it has been removed as a suggestion. All-in-all this looks like it will be a great bag. It will be my carry-on but seems sturdy enough to gate check on smaller planes.

I couldn't be happier. This cart rolls over anything and carries all my gear. The only slight problem is if you load the rear with more weight than the front, the front wheel wiggle and increase resistance to push. Design questions, changes... why not make the deck a bit wider. It would allow for more gear between the hands (light stands, tripod, etc), and since there are wheels blocking the bottom rail, put something to hook onto for bungee cords.