Front Load Washing Powder

Lost this light at least 9 months ago, was pulling a load of towels out of the washing machine and this fell out........to my amazement the thing turned right on, original battery.....A little rusty put its definitely clean now, tough tough light.

Since COVID we are streaming to YouTube but the camera was very near the ceiling and always had the ceiling lights in view and washing out the front of the room. By adding the extender we got rid of looking at ceiling lights and the washout.

Thought i lost this little torch, 9 months later it falls out off my washing machine, got stuck behind the front rubber door Gasket, still has the original battery that came with and it turned right on, A little rust near the ring that's all the damage it suffered. I'm a fire inspector and use this a lot to read gauges and find hidden no no's in back rooms, this light rocks don't hesitate just get one!

So much easier than dektol powder.

Use for BxW negatives after washing

A very simple and affordable solution to print washing.

Load everything up and move it from one location to the next. All my equipment fits perfectly. Collapses down to fit in the front seat area of my car, with the wheels on the floor. Don't need a truck just yet.

I haven't actually used this yet, but I did load it, weigh it, and pretend to put it in an overhead for practice. Seems perfect for my gear. I travel with a DLSR, mirrorless and 4 lenses. There is room for that and a change of clothes if a bag gets delayed. The front compartment easily holds my 15 laptop. The laptop compartment sort of locks by attaching the loop on the zipper to the integrated lock for the case (watch the video). The case rolls easily. I agree with the reviewer who said it would be nice if the bottom of the case was flat, but with my gear that is not a problem. The recommended accessory GRID-IT organizer of 10X12 does not fit the interior front pocket and looks like it has been removed as a suggestion. All-in-all this looks like it will be a great bag. It will be my carry-on but seems sturdy enough to gate check on smaller planes.

I couldn't be happier. This cart rolls over anything and carries all my gear. The only slight problem is if you load the rear with more weight than the front, the front wheel wiggle and increase resistance to push. Design questions, changes... why not make the deck a bit wider. It would allow for more gear between the hands (light stands, tripod, etc), and since there are wheels blocking the bottom rail, put something to hook onto for bungee cords.

This is a great day/travel bag for taking your camera and a spare lens. To me, it's one step up in complexity/organization from a peak design neckstrap, which I also have and use, for days when you want to grab the camera, but also second lens and extra battery. The bag wears comfortably, wraps around your back when not in use, swings around to the front, and you can wear it as a fanny pack (though I haven't). There are nice little nooks and crannies for extra batteries, cords, etc. The flexibility and capacity of the bag is a double-edged sword. Yes, you CAN load it up, a lot, and if you are flying somewhere and need the capacity, it's there. You could do an 80D with a 18-135, two pancakes on one side and an 85mm on the other, and have room to spare for more. But, if you really load this up to maximum capacity, it starts becoming like a traditional heavy camera bag, a psychological and physical burden that detracts from actually leaving the house, being mobile and taking out your camera quickly and actually using it. Just my thought process. One less that great thing... the front pocket is a little hard to access, for me, especially if the bag is full. It could have been made just a tad more roomy, maybe with some more give on the sides. As is, the cloth is very tight and you kinda have to pull it apart and plunge your hand across a sharp-ish zipper to get in there. Know what I mean? Maybe the next generation addresses that.