Ge Front Load Washer Key Light On

5 stars! Stable and very easy to adjust level with slider on.

Light for the load it can bear.

Great lamp from GE, it has some more lumens compared to the generic ones. As a commercial photographer, continuous quartz light is among my favorite kind of light.

Someone please tell me any other film washer better than this.

You can use them as a third hand. You never have enough clamps ge tthe bundle its worth it.

Wraps light around subjects as a Key light...

Bought this after trying a GE which would not connect. No problem with the Kasa, it worked right away.

This 12 Floodlight Reflector by Impact is perfect for 2-3 light setup. This item is very light and easy to install without problems. Their is no negative comments about this product. When installing the reflector with the Impact socket ceramic lamp holder, make sure you place the supplied 1silver washer inside the reflector before you screw it in place with the supplied large aluminum nut(type) the goes over the ceramic socket. When you do place the 1 washer outside behind the reflector, screwing the aluminum nut(type) will be difficult. although small hands can get it tighten, but large hands will be a problem.

I bought the light a few years ago and loved it. Till i put it throw the washer and dryer my fault. But absolutely love it when i had it

I just received my ION and will be using it this weekend for a wedding shoot. While I haven't had real world experience with it my testing in the studio has all been positive. The ability to throw a lot of light with my strobes vs. trying to bounce a speedlight off a cocktail napkin will open up a new world of possibilities. For some reason I find myself doing a lot of Golf Course weddings and being able to go cordless should be very helpful. The quality of the product is great. It recharged quickly and it doesn't weigh much so moving it around is a piece of cake. The only caution I'll throw out is that the bracket that attaches to your light stand may need some adjustment before you try and mount the battery. The screw that holds that bracket to the stand has a washer that I assume is intended to protect the light stand. There's a screw that holds it (the washer) to the bracket and mine wasn't screwed in fully. When I tightened that bracket to the light stand the screw head put a nice dent and scratch in the stand. Not the end of the world but slightly annoying. Other than that, all good and well worth the investment.