Ge Front Load Washer Suspension Parts

One look at these parts and you realize that they are nicely made, high quality and well thought out. The manufacturer provides a nylon washer that fits inside the bottom of the female thread to cushion the fully engaged adapter. Pleasure to see this quality.

I own both a Rycote Windshield Kit 4 and Kit 2. The only improvement I would recommend making is to order an optional stiffer Rycote Grey 82 Lyre Upgrade Set--Part #042216--and install one Grey Lyre on the front side of the suspension mount while using a Black 72 Lyre on the back of the suspension mount (or replace both black lyres with grey lyres if you see fit). The grey and black lyre combination works exceptionally well with the Sennheiser MKH-50 in reducing some of the potential handling noise prone to all MKH-50s. It also works great with my Rycote Windshield 4 Kit housing a Schoeps cmit5u. I know everything boils down to personal preference, but for me, running a Grey 82 lyre in the front and a Black 72 lyre in the rear of the suspension mount is a winning combination for both isolation and feel.

Best suspension for the money.

Someone please tell me any other film washer better than this.

You can use them as a third hand. You never have enough clamps ge tthe bundle its worth it.

Bought this after trying a GE which would not connect. No problem with the Kasa, it worked right away.

I did not encounter any issues with assembly. A stub screwdriver is included but you'll want to use your own nicer one because the parts of the rack come with numerous screws pre-screwed in which have to come out first. I screwed together all parts loosely first followed by tightening to help with hole alignment. I had also purchased a shelf and appropriate mounting hardware but the extra hardware was unnecessary because the baggies of 10-32 screws and 12-24 screws that were included with the rack were more than sufficient. Very minor notes: the Auray badge stuck to the front was also offset on my rack, and, the main B&H image of the rack shows the back plate below the front edge of the top which is a little funny because the manual indicates it's to be installed on the back--not that it matters.

I got this case recently and have had nothing but a great experience with this case. Beautiful RGB lighting on the front, great airflow with the mesh on the front. All of my parts go nicely with the case as well. I previously had an NZXT H510, although that looked nice as well, this TD500 not only looks nicer, but also as I mentioned has much greater airflow. If you are going to build a PC and cannot decide what case you want, trust me when I say that this case certainly is a great choice.

Load everything up and move it from one location to the next. All my equipment fits perfectly. Collapses down to fit in the front seat area of my car, with the wheels on the floor. Don't need a truck just yet.

I haven't actually used this yet, but I did load it, weigh it, and pretend to put it in an overhead for practice. Seems perfect for my gear. I travel with a DLSR, mirrorless and 4 lenses. There is room for that and a change of clothes if a bag gets delayed. The front compartment easily holds my 15 laptop. The laptop compartment sort of locks by attaching the loop on the zipper to the integrated lock for the case (watch the video). The case rolls easily. I agree with the reviewer who said it would be nice if the bottom of the case was flat, but with my gear that is not a problem. The recommended accessory GRID-IT organizer of 10X12 does not fit the interior front pocket and looks like it has been removed as a suggestion. All-in-all this looks like it will be a great bag. It will be my carry-on but seems sturdy enough to gate check on smaller planes.