Ge Monogram Counter Depth Refrigerator Door Shelf

The door really closes like a refrigerator, has a good seal. The glass door is strong and the operation of the humidity control is absolutely silent. In approximately 2-3 hours reaches the control of 40%�humidity with 1% oscillation only. Internal space totally free without technical cabinet artifacts.

The people at B&H are just amazing. They took the time to make sure everything worked before I left the counter. They pulled my camera off a shelf and fit the piece. I love B&H :)

our refrigerator is covered with them!

This clamp can hold a 580EX II wherever you want, like in a door, a desk, a chair, a pipe, a shelf... It stays in the position you left it and you don't have to adjust it all the time. I use it to hold a 580EX II controlled by another one in my 50D

When I was shopping for a dry cabinet, I looked at a few options, and decided to get this one. So far, its been good but not perfect. It keeps dry even if you unplug it a few hours. It feels solid, and its made of 1 mm thick powder-coated steel including the shelf. The hinges and shelf clips are 2 mm thick powder-coated steel. It makes a solid sound if you knock on it, and the door sounds like opening and closing a nice refrigerator. Out of the box, the handle comes on the inside of the door, so you have to take it off and mount it on the outside. You get two pieces of precisely cut open cell foam. One is sized for the bottom, and one is sized for the shelf. It runs off a small power brick with an L-shaped barrel connector that plugs into the back of the cabinet and puts out 5 volts 2.0 A, so its basically like a small iPad charger. The dehumidifying unit is on the upper center, and there is a cable neatly routed above the shelf rails to the control board in the front of the cabinet. Theres a single light bar on the front right that illuminates the interior. Its daylight white and a good brightness. It plugs into the control panel and you can turn it on or off from there. The screen on the control panel is easy to read with large letters, and you can adjust the display brightness between bright and dim. The controls arent the most intuitive, but once you read the instructions, its easy to use. The only complaints I have about this cabinet have to do with the lock which I dont use and the shelf placement. You cannot place the shelf in the center of the cabinet if you want to use the lock. In the lower position, the door will not close because the lock will hit the shelf. In the other position, the shelf prevents the lock from turning. The keys are really cheaply made and are probably stamped instead of cut, and they are quite roughly made with cheap-feeling plastic heads. In some upper positions, the dehumidifying unit also interferes with the shelf.

I use this for a monogram light using my laser printer. I had to print twice over to ensure that the black areas were as black as possible.

Had to search to find this full depth shelf to fit all my components for a Go-Box of Ham radio equipment. Perfect fit, sturdy and well made.

The Auray RS-2U rack shelf with a shelf depth of 14.25 inches was ideal to rack mount a 750 VA UPS. The unit was solidly constructed and worked well. The heavy duty rack used in this project was tapped for 1/4x28 rack screws. The mounting holes were slightly small for the 1/4 hardware and had to be slightly drilled out for a fit. No problem!

We used this to connect our patch panel to the switch below in the rack. Because of the depth of the UPS and Server in the rack the front rails were very close to the front. This results in very little clearance for cabling to the front door of the rack. These patch cords bend tightly, allowing the rack door to easily close.

I understand the first version of this plate was a bust. It blocked the battery door. Not so this version (B). Adds 1/2 depth to the grip, making it somewhat more comfortable, while adding the Arca-Swiss compatibility.