Ge Monogram Counter Depth Refrigerator Panel Ready

So far so good. I have it hooked up to my refrigerator and a 200 watt solar panel.

articles were ready for pick up as I approached the receivable counter

This setup is used to power our refrigerator and freezer during power outages. The Delta 2 and extra battery is charged with an EcoFlow 160 watt panel and/or a propane powered generator AC port. The Delta 2 is easy to manage through the app and I hope to purchase an additional solar 160 watt solar panel and an EcoFlow Smart bi-fuel generator to supplement our setup.

Not too long after recieving my delta 2, my parents were having a new electrical wire run. A hole had to be drilled near the electric panel to get the wire from the attic and into the panel location, little did we know some wires came in from a different direction. one well placed hole later took out all the kitchen outlets including the fridge and, until all the circuits had been removed from the panel and repaired, the ENTIRE HOUSE could not be cut back on. I grabbed the delta 2, did a fast charge up to full (Amazing to charge in the blink of an eye) and took it over to power the refrigerator for the duration of the repair. I wasn't expecting it to get used so soon, but it ended up being so much easier than trying to get out a generator and run cords through the house. we just set it on the counter, connected the refrigerator and were good to go. They actually have a whole home generator, but since the problem was inside the house the generator was useless. Having this much power be so portable and usable anywhere is truly amazing. We have since used it a bit more, including connected to solar and as a UPS during a final exam in the middle of a storm. The ease of everything really is the value here, there's no messing around with modes or configurations to go from power station to UPS to solar to car charging. Everything just works and gets out of your way.

our refrigerator is covered with them!

I use this for a monogram light using my laser printer. I had to print twice over to ensure that the black areas were as black as possible.

Have a high end refrigerator that is plug in into it, so far so good!

We used this to connect our patch panel to the switch below in the rack. Because of the depth of the UPS and Server in the rack the front rails were very close to the front. This results in very little clearance for cabling to the front door of the rack. These patch cords bend tightly, allowing the rack door to easily close.

You can use them as a third hand. You never have enough clamps ge tthe bundle its worth it.

This is a great set of reflectors for on-the-go applications. I can toss them in my bag and have one ready in an instant. The diffuser panel is especially helpful in sunny situations.