Good Hard Drive Enclosure

I used this internal hard drive with 3 others for my Four Bay Hard Drive enclosure. Easy to install, didn't give me any hard time. It's fast enough.

Compact enclosure, a 9 mm hard drive fits perfectly (which is good since that means it won't move in the case, preventing damage if it falls).

Used this drive in an Avastor HDX Pro external Hard Drive Enclosure. It was easy to install and format and has worked very well for the past three weeks at least. Am currently using it for video files with no issues.

If you have a lot of loose hard drive but don't want to buy an enclosure for each drive, you need this docking station.

This is my third Storejet enclosure. It's an easy way to take a hard drive from a laptop destined for recycling and repurposing the drive as an external USB drive.

This enclosure was a great add-on to my QNAP TS-832X. Added 8 more hard drive bays over 2 SAS cables. Great bang for your buck!

gutted the 1.5TB hard drive in this, put it into my drobo, and took a 500gb wd green and put it in this enclosure. works just fine. i like the fact that the enclosure is nice and minimal, no gaudy neon lights or whirring fans, which are completely uneccesary in hard drive enclosures.

Perfect for replacing a hard drive but still wanting to use the old one. My external hard drive broke but luckily it was the enclosure that was damaged so I removed the hard drive from the enclosure and got this adapter to be able to continue using the hard drive

I had an old 3.5 WD external hard drive that only had a USB 2.0 connector. I bought the Sabrent enclosure so I could use USB 3.0 instead. Once I removed the hard drive it was easy to install it in this new enclosure. You need to pay attention to the instructions and angle the drive to properly seat it into the SATA connector. I haven't tried removing it, but I don't need to. This enclosure uses a power plug. It's not bus powered. I do like that there's an on/off switch. Overall, what else can I say? It's a simple solution that works. I'll definitely be buying more of these.

Using the enclosure for external drive on MacBook Pro 13 unibody. Wanted the Firewire 800 speed for an external bootable drive. Found it best to follow instructions of NOT screwing the hard drive down to the heat sink(even though there were enough screws in the package to do so). As it turned out two of the drives I was using were bad so it was easy to just open the end-cap and slide the I/O board with hard drive out to replace then slide it back in. The two end-caps (one permanent the other has screws to hold it in place) hold parts inside fairly well with a 2.5 5400 rpm SATA hard drive. This case is not intended to be water-proof, shock-proof or dust-proof etc. Just an enclosure for an external hard drive best used laying flat and still. Happy with the fact that package includes USB 2 to USB 3 cable as well as Firewire 800 cable. device is capable of daisy-chaining Fireire 800 devices since it has two ports. Included is a pleather carrying case. Has a tiny on-off switch. Case is see-through clear plastic with reasonably thick construction. The blue LED when turned on is a good visual cue not to shake or move the enclosure as the hard-drive is on and spinning. Careful not to tighten side screws to hold the end-cap in place is they may strip or crack the plastic piece.