Guitar Amplifier Used As Speaker

From time to time, I need the use the guitar input of my amplifier for a second microphone input - this gizmo enables me to do that withous issues.

I bought a pair of these to use with a guitar amp simulator. They sound great and allow for getting the amplifier and effects tone without having to crank up the volume to concert levels.

In 1969 I saw a solid-body electric guitar with a three-inch amplifier built into the face of the guitar. The tiny speaker was powered by a nine-volt battery inserted in the back of the instrument. Fantastic, I thought, why don't they make a suction-cup amp that sticks onto the face of the guitar? A zillion years later they did and it is fine.

Great mic for any kind of use. Vocals sound great as well as guitar and bass amplifier. I use this mic in my home studio and live performance.

The sound is excellent and it looks amazing with this retro design and guitar amplifier style! 20+ hours of battery charge life it`s truth, not joke!

Very nice cables. I use it to connect a tube preamp to guitar amplifier and they work great. Love the color!!!

Used to cary multi effect system for my bass guitar

Used as a keyboard amplifier. Plenty of power to rock the studio while not hurting my speakers or distorting.

imho, you should skip the old 'receiver' and upgrade to a new Integrated Amplifier like this Yamaha unit. When shopping to replace my receiver i stumbled across an article on cnet about integrated amps. After spending a couple hours learning about these devices and finding a unit with an a/b speaker switch (for my speakers in the backyard), i selected this Yamaha unit.Never going back to a Receiver...easy to use, great sound (thd about 0.019), performs exactly as expected. great value too. Only 'con' is that it should allow for independent audio sources for each speaker set.

Even though I have experimented with stereo systems for almost 50 years, I had never bi-wired speakers until I recently purchased Bowers & Wilkins 603 floor-standing speakers. I was intrigued by their bi-wiring option that Crutchfield suggested could provide noticeable improvements in the overall transparency of your loudspeakers if I ran separate speaker wires to the low and high frequency drivers from a single amplifier. After doing some research, I discovered the Canare 4S11 bi-wire speaker cable at B&H. I don't claim to have golden ears, but I do want better sound at a reasonable price, so the Canare cables were interesting. However, I have to admit that to my eyes they looked sort of flimsy in the online picture, so I debated with myself about spending over $130 for two sets of 10-foot cables. Therefore, I was thrilled to discover that the two runs I ordered are not only substantial in diameter, they are professionally terminated with high quality banana cables that give me a tight fit into my vintage Audible Illusions S120 amplifier and my new B&Ws. While I can't tell you that the heavens opened and angelic choirs sang when I plugged them in, the speakers sound wonderful and I am now looking at upstream improvements in my system, including the RME ADA-2 DAC FS. My conclusion is that it only makes sense to bi-wire speakers if the speaker designer provides the option. So for me this was a great purchase. If you have speakers that offer the bi-wiring option, I highly recommending giving these a look.