High Pressure Water Pipe For Car Wash

Great for cleaning out PCs, dusting off blinds, and getting water out of your mirrors and grilles after you wash your car.

If your lens needs a cap then this is what you want. It wont wash your car but it will keep your lens clean.

My wife accidentally tossed my original Pro Pen 2 into the wash and while it was usable after drying out, much of the pressure sensitivity was gone. I had been getting by with the original Pro Pen since Wacom has been sold out of the Pro Pen 2 since introducing it, but you quickly miss 8k levels of pressure sensitivity, so being able to pick this up was a life saver.

Have it's big brother also but this is great to grab to go out back to wash and vacuum the car. . .

Reduces wash time significantly, saving water and time. And a little goes a long, long way.

I know this clamp is useful for much more than attaching a GoPro to a car top or pipe on a safari truck, but it works great for this. I don't have to make sure the windshield is clean or if there will be a glint on the windsield. I also don't have to worry about it coming off. You clamp this thing on and the GoPro isn't going anywhere. It comes off easily too. The only downside is the weight/size. This is a serious clamp that will hold your gear securely. It is kind big though.

Good coverage and tools wash off in soap and warm water. Always do your UV paint jobs in UV lighting so you know what your final product will look like of course.

I have zero water spots or drying issues with my negatives using this product, and this product is probably the most cost effective purchase you can make to improve the quality of your negatives. That being said, knowing a little about your water chemistry in your home will help you. The amount of photo-flo you will need to add depends on how hard the water you will use for the final wash and rinse of your negatives will be. Assuming you use distilled water to mix your chemistry, this means any tap water you will use to wash and rinse after fixing. If you have water spots on your glasses, stains on your bathroom fixtures, and or can taste mineral or metals in your water, you will likely need to use the strength of the suggested ratio for this product. If you have a water softener, salt based or otherwise, you will likely only need a few drops of this product per liter to get great results. The final solution should bubble only slightly when agitated and NOT foam like the head of a beer.

I use this to wash my developed film (from a lab)to remove excess dust and water stains. Works great !

Use 2 drops per 10 oz of water after final wash of film. Submerge film in photo-flo/water solution for 15 seconds. Only SLIGHTLY agitate film (to avoid bubbles). Dries lovely, with no streaks or spots.