Hot Water Pressure Wash Vinyl Siding

My wife accidentally tossed my original Pro Pen 2 into the wash and while it was usable after drying out, much of the pressure sensitivity was gone. I had been getting by with the original Pro Pen since Wacom has been sold out of the Pro Pen 2 since introducing it, but you quickly miss 8k levels of pressure sensitivity, so being able to pick this up was a life saver.

Reduces wash time significantly, saving water and time. And a little goes a long, long way.

Great for cleaning out PCs, dusting off blinds, and getting water out of your mirrors and grilles after you wash your car.

Good coverage and tools wash off in soap and warm water. Always do your UV paint jobs in UV lighting so you know what your final product will look like of course.

I have zero water spots or drying issues with my negatives using this product, and this product is probably the most cost effective purchase you can make to improve the quality of your negatives. That being said, knowing a little about your water chemistry in your home will help you. The amount of photo-flo you will need to add depends on how hard the water you will use for the final wash and rinse of your negatives will be. Assuming you use distilled water to mix your chemistry, this means any tap water you will use to wash and rinse after fixing. If you have water spots on your glasses, stains on your bathroom fixtures, and or can taste mineral or metals in your water, you will likely need to use the strength of the suggested ratio for this product. If you have a water softener, salt based or otherwise, you will likely only need a few drops of this product per liter to get great results. The final solution should bubble only slightly when agitated and NOT foam like the head of a beer.

I use this to wash my developed film (from a lab)to remove excess dust and water stains. Works great !

Use 2 drops per 10 oz of water after final wash of film. Submerge film in photo-flo/water solution for 15 seconds. Only SLIGHTLY agitate film (to avoid bubbles). Dries lovely, with no streaks or spots.

Water is expensive and time is valuable. Ilford Wash Aid makes it possible to cut your washing time by 80% saving you time and money.

I use this as with my final wash. I fill my development tank with distilled water, then add a few drops on LFN, agitate for two minutes, take out the film and hang to dry. The negatives always come out great and smooth and have no spots.

I use Photoflo as a post final wash rinse for my film before I dry it. Photoflo is great at eliminating water spots and even great for washing film that has been handled and just needs a sprucing up. It goes a long way, too.