Level French Door Refrigerator

The door really closes like a refrigerator, has a good seal. The glass door is strong and the operation of the humidity control is absolutely silent. In approximately 2-3 hours reaches the control of 40%�humidity with 1% oscillation only. Internal space totally free without technical cabinet artifacts.

our refrigerator is covered with them!

Have a high end refrigerator that is plug in into it, so far so good!

Even better than promised. Will try hooking it to my refrigerator.

Strong enough to hold up a refrigerator, I think. Fits perfectly, of course.

I've been working on a stable platform for shooting video from a car/safari vehicle. The main problem is that most video heads for tripods have a leveling handle under the head making it hard to mount and level on a vehicle door. This leveling device allows me to use a smaller video head on a flat platform strapped to the car door. That silver ring has to be loosened to level the head. The only problem is that it takes 2 hands for me to loosen it, level and then tighten it again. If it was a little wider it would be easier to loosen with one hand and maybe faster to level.

I use this in areas where I cannot get out of the car. I go on a wildlife drive and it's not safe or allowed to be in the same area with Bison. I use this Car door lens support mount with a Wimberley WH-200 Gimbal head. My lens setup is a 600 f/4 II prime with a 1.4 or 2x III extender. I can rotate it enough to get it inside the window so I can close the window during cold weather months. You can either mount it inside or you can mount it outside of the vehicle on the door with some minor modification. It has a bubble level which is nice but I rarely use it because the vehicle is rarely on a level surface. I use the in camera level instead and adjust the camera accordingly. I do shut off the car at times to get sharp photos and avoid motor vibration. This is an awesome setup but you are limited to the side you have it mounted on. I would keep a smaller 100 - 400 handheld setup to take photos on the opposite side of the vehicle. The screw does want to thread into the metal. which can make it difficult to remove the gimbal at times. I just make sure I apply upward pressure on the knob to avoid it hopefully they will fix this in a future revision but not a deal breaker.

Connected to my River, kept my portable refrigerator going all weekend

Great quality but the package was missing the french flag

It's a nice set of filters to use in my matte box with french flag.